Head lights lights wont go down

try this head torgue link.. that wont highlight

http://www.cylinderheadsaustralia.com.au/torque-settings

the ZD30 is listed half way down the list
and picture of tension sequence

HEAD BOLT TIGHTENING SEQUENCE.
• STEP ONE: 102Nm
• STEP TWO: Loosen All Bolts.
• STEP THREE: 44Nm
• STEP FOUR: +90*
• STEP FIVE: +90*
• IMPORTANT: ALL BOLT THREADS, BOLTHEADS AND WASHERS MUST BE LIGHTLY OILED.
• USING AN OLD HEADBOLT WITH GROOVE CUT DOWN THREAD, CLEAN THE BLOCK HEADBOLT THREADS.




why are these torque setting and sequence
numbers no longer on the VRS head gasket packaging

get flash light looh in dist. mounting hole get long flat head screw driver insert into hole and turn oil pump shaft as needed

If you need further help, reach me via phone at https://www.6ya.com/expert/james_9c1b039055413ffa

check the motor that pops up the light

.First check fuses in fuse box inside vehicle,if good then,Go to head light with meter,remove connector,turn lights on and see if you have power,do both,if no power then maybe switch.Here's the switch.

it could be the fuse.you dont want to look at the alternator just yet so start at the fuse box and work your way to under the hood down by the head lights theres k

check right side fuse for right side head lights

Have you checked the Rt and LT head light fuses in the power distribution center under the hood?

remove the spark plugs and turn the engine over could be the head gasket if so the stop leak additive is a tempory soloution to a perminent problem. replace head gasket

check the fuse first if the fuse is good and both head lights won't go down check if the head light switch in the middle of the dash is good