2005 Toyota Tundra SR5 Logo

Related Topics:

A
Anonymous Posted on Feb 01, 2014

My 2005 toyota tundra keeps blowing ignition switch fuse when I try to crack it

Keeps blowing ignition fuse when I try to crack it

5 Related Answers

Anonymous

  • 6 Answers
  • Posted on Dec 13, 2008

SOURCE: keeps blowing 15a efi fuse 1991 toyota pickup 2.2 re

there's a short somewhere causing that amperage to go up

Ad

Anonymous

  • 101 Answers
  • Posted on May 03, 2009

SOURCE: I have a 2004 toyota

Its possible the 4wd actuator on the transfer case is sticking from lack of use. Its a black plastic part located on your transfer case on the drivers side rear with a electrical connector attached. Tap on it lightly while someone activates the 4wd button. Have truck running in neutral with foot on brake. (dont get run over). If it goes into 4wd, then just remember to cycle it into 4wd and back again once or twice a month to keep it from sticking.
If all this doesn't work a dealer will need to look at it.

Anonymous

  • 169 Answers
  • Posted on Aug 30, 2009

SOURCE: My engine fuse keeps blowing on my 1984 Toyota 4

It could be driver or manufacturer if this eng always blows on other people must be your driving or maintenance or saba toge

Anonymous

  • 1 Answer
  • Posted on Sep 02, 2009

SOURCE: Toyota Tundra 2005. ABS, Airbag, Tire & cruise dash lights flash

how do you turn the maintenance light off after making oil change?

Anonymous

  • 1 Answer
  • Posted on Jul 20, 2010

SOURCE: am2 keeps blowing up

Its most likely the capacitor on the distributor. Remove the distributor cap and rotor. Under the coil on the right hand side is a cylindrical capacitor about 1/4 length of a AA battery. remove and replace. It's about a $5 part and an easy fix. If you go to NAPA AUTO PARTS, the part # is: RC102. The UPC # is 7-0739090352-1. The description is Distributor Capacitor and Terminal.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

2006 Toyota Tundra Double Cab keeps popping IG/ECU fuse when the truck is moving.

IG /ECU fuse blows.
IS FUSE IN THE CAB OR ENGINE BAY?
JUST ONE FUSE? NO AMPS TOLD TO HELP ME,
no ENGINE told (4.0L v6 or 4.7 v8



the service manual on pages for PCM schematics clearly shows all things on that fuse to cause it to blow (i must assume correct fuse is there)

i am reading it to you now.

THE USERS MANUAL IS HERE (LOST?)
493 PAGE IS FUSES./
PAGE 494 SHOWS IT AS

. ECU IG 5A:
Anti?lock brake system,
vehicle stability control system
,multi-plex communication system ,
tire pres-sure warning system



USERS GUIDE
https://assets.sia.toyota.com/publications/en/om-s/OM34458U/pdf/OM34458U_edited.pdf


TO FIND THE SHORTED MODULE IF NOT WIRES SHORTED
PULL TPMS MODULE (TIRE PRESSURE)
THEN PULL , ABS CONTROLLER NEXT
AND IF STILL BLOW THE FUSE THE MUX PARTS MOST BE TRACED OUT
0helpful
1answer

Can the camshaft sensor blow EFI fuse?

need a meter to test ignition system switch--harness--relay -starter
0helpful
1answer

I have a 2009 Toyota Corolla. Recently the wiper fuse started blowing. The Fuse keeps blowing as soon as the ignition is turned on.

could be anything and without a look myself i couldnt tell you try disconnecting the wiper switch and see what happens is about the best i can come up with was thinking of the self park but with motor disconnected and it still blows ?? thats that out the equation .
0helpful
1answer
0helpful
1answer

My crank fuse keep blowing what cause it to blow

Ignition Switch / Starter Fuse keeps blowing. - CarGurus

www.cargurus.com > Questions > Ford > Focus
CarGurusAug 14, 2010 - Ignition Switch / Starter Fuse keeps blowing. - I own a 2002 Ford Focus, 2.0l SPI engine. 5-speed manual trans. Recently bought from a friend's ...
0helpful
2answers

Ignition fuse switch keeps blowing

you have a short in that circuit chck your harness for wiring that might be exposed to ground or pinched
0helpful
1answer

Where is the alarm system reset button on a 2000 Toyota Tundra? My alarm keeps going off and I can't crank it.

I am having the same problem. Replaced ignithion swithc, starter relay. Battery is good, but alarm keeps going off, and will not crack the engine. Please help with any recommendations!!
4helpful
2answers

Just replaced battery on 2005 tundra, how do I reset the vehicle alarm. The alarm now sounds whenever I open the doors.

Anytime the alarm sounds when opening the door with the key, get into the truck anyway, place the key into the ignition key switch and turn it on and off 2 times. The horn will stop blowing and the lights will stop flashing. You're ready to go.......
1helpful
1answer

Blows 15amp ecm fuse

replace ignition switch
1helpful
1answer

Tail lights and dash lights not working, keep blowing fuse.

you have a wire or a light socket grounding out ck were your lights go into the sockets has the car been wrecked any were near the lights if it has thats were you start if not start with your light sockets
Not finding what you are looking for?

451 views

Ask a Question

Usually answered in minutes!

Top Toyota Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...