I have a 2006 jeep grand cherokee that i disabled the seat belt alarm by reading the manual. Now when I buckle my seat belt the chime goes off everyone once in a while. Sometimes a lot! Usually happens when I turn the wheel. Any suggestions how to fix this? I have tried enabling the seatbelt chime again but couldnt get it to reset back to factory chiming.

There is an electrical contact in the bottom of the seat belt buckle, and associated wiring that has a connector under the seat. Check that with a multimeter for continuity.

Also, this is a function of the Body Control Module, so you may have a communication problem. This can only be solved or confirmed by getting an auto electrician to connect a pro grade scan tool computer to the OBDII port and checking.

https://www.google.com/search?q=2006+jeep+grand+cherokee+disable+seat+belt+chime

..

either failing seat switch or female buckle ---check wiring to both

I would cut the two wires going to the seat belt buckle and twist them together. sounds like it needs a new buckle anyway so cutting the wires isn't going to ruin anything

Make sure you have nothing laying on a passenger seat since these are also equipped with sensors.
If these are free, try checking under your seat for wiring that has been damaged or become disconnected.

Why would you want to disable it?

The seat belt does not work on an ignition locking device. Need to remove side panel and visually inspect roller and gear locking mechanism.

what is the chime for? door ajar? seat belt not buckled? if you solve the problem the chime will go away

This is the seatbelt indicator, its not seeing that your seatbelt is fastened ifthe light stays on and the chime keeps going off.

There is a switch inthe seatbelt that closes when the seatbelt is buckled, and if not, thelight stays on and the chime goes off.

There are a couple reasons thiscould happen. It could be a wiring issue going to the seatbelt buckle,or more likely the buckle itself. Your truck is pretty new, so if youare under 36,000 miles the repair would normally be covered underwarranty.

Also, I suggest check the Repair Manual for Jeep-WK-Grand-Cherokee-Section-08O-Restraints (page 473 and next, for Seat Belt)

Hope helps with this (remember rated this) Good luck.

take wire harness apart underseat that connects to seatbelt on drivers side. then take a piece of aluminum foil and stuff it into male part so it makes contact with both prongs and plucg connection back together..problem solved!!!!!!

Hi
There is a switch in the seat belt latch whe your sitting in the seat this will ba the part o the right side, see if something went into the latch part? or the switch is bad i think you have to replace the belt to fix the switch
RD