So why not scan it.
Connect any scan tool
crank it for 5sec.
release key,
see those DTC's they tell you what part is bad, or a huge clue.
wires, you replaced them 1 for 1 or mixed them.??????? oops now 2 times bad.
but no spark is no spark, on ALL CYLINDERS>????
no SPARK?
which engine
2.0 L 3S-FE I4 (petrol)
2.0 L 3S-GE I4 (petrol)
this engine has a coil pack with 4 wires, never mix them. that wires.
and do check for spark at all 4 ends.
see the coil pak here, see those numbers there. they tell you
where to connect the wires.
http://i.ebayimg.com/00/s/NzY4WDEwMjQ=/z/6hUAAOxycmBSsg5O/$_57.JPG
this photo even shows, where they go.
if spark is gone, ITS SCAN TOOL TIME.
barrow one, rent one, buy one of $9 (off fleabay)
this ECU/PCM will in fact tell you if the CMP or CKP sensors
are dead. IT WILL.
if you dont believe me, unplug one and see, BAM, P0340 or 355 or?
SOURCE: bad stumble on acceleration pops through t- body.
Sounds like the fuel pressure regulator. Could also be that the timing jumped. But I'm leaning towards the pressure regulator. Hope that I could help. Best wishes.
SOURCE: changing spark plug wires in 1998 camry
You aer not clear about your problem, when replacing plugs and wires all the boots need to stay in place, the larger boot goes around the spark plug, making sure the metal is secure around the tip of the plug, the oppisite end fits the distributer cap, making sure the metal at the end of the wire is securely in the hole. You said you have 3 boots, you should boots for each end of each plug wire and a plug wire for each spark plug
SOURCE: check engine light flashing already
It could be a bunch of things, any oxygen sensor, cam position sensor, crank position sensor, air inlet temp, any of these things will trip off the engine light. You have to get your car to the parts store and get the scanner on it and see what codes come up, you can replace parts forever and not hit it. Save your old parts, they are probably still good. Coil packs are expensive. Check it out, hope this helps.
SOURCE: i have 3 coils on
TRY THIS FRONT 3 CYLINDERS FACING YOU LEFT TO RIGHT 2 4 6 AND BACK CYLINDERS LEFT TO RIGHT 1 3 5 NOW TAKE THIS NUMBER 5 1 3 THIS IS SPARK PLUG WIRES LOCATION FROM LEFT TO RIGHT.PUT PLUGS WIRES TO THE 3 BACK CYLINDERS IN SAME ORDER YOU SEE NUMBER.LET ME KNOW WHAT HAPPENS.
310 views
Usually answered in minutes!
×