SOURCE: Head bolt torque specs needed for 96 tbird 3.8
Head bolts are torque to yeild so you MUST use new bolts.
Tighten cylinder head retaining bolts in numerical sequence in three steps as follows:
Loosen retaining bolts one at a time two to three revolutions and retighten as follows:
Long bolts:
Short Bolts:
Here is a pic of the sequence
http://i253.photobucket.com/albums/hh43/chuck943/Headboltsequence38L.gif
SOURCE: head bolt torque for a 1996 ford ranger 2.3liter
it is in the haynes repair manuel and chad is right
SOURCE: Head gasket torque specs
Here you go, I hope this is what you were looking for:
For 1987-94 models, the cylinder head bolts are tightened in 3 progressive steps. Tighten them in the proper sequence as follows:
Step 1: 50-55 ft. lbs. (68-75 Nm)
Step 2: 60-65 ft. lbs. (81-88 Nm)
Step 3: 70-85 ft. lbs. (95-115 Nm)
Let me know if I can assist you with anything else.
SOURCE: head bolt torque spec
Always use new head bolts.
1)tighten to 40ft/lbs
2)back off 1/2 turn
3)tighten back to 40ft/lbs
4)tighten an additional 90 degrees
5)tighten an additional 90 degrees.
SOURCE: whats the torque specs on a 2001 ford focus 2.0
You need to buy the manual, because you also need to know the order in which to torque them.
http://www.car-stuff.com/mmparts/ford-focus/repair_manual.html
usually you start at the middle and circle outward.
But they can differ. Some cars you always need to put in new head bolts. Others are done in several stages. This is too critical to take chances on.
If you really can't afford $19 for a manual, go to the library and xerox the pages.
1,766 views
Usually answered in minutes!
×