Question about 2004 Dodge Ram 3500 Truck

Open Question

Error code 0633 can get truck to start then looses fuel after 5 miles

Posted once before havent gotten any response cleard the other codes only code left is 0633 that it doesnt recognize my key if i play around with the door locks and cycle the ignition switch i can get it to run but either not for long or at the most 5 miles then it wont start or it will only start then quit right away it has done this to me severaal times to the point ii cant drive the vehicle cause i know it will quit after 5 miles is thsi some type of security deal it seems to me this problem all started when i replaced my batteries please help

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

hammerhead30

  • 6 Answers

SOURCE: 91 Dodge ram 50 ignition problem, rough idle in drive,dies when braking

my ram 50 starts just like any other vehicle, (no light switch pulling whatso ever), it sounds like somebody haas rewired something wrong or you have a loose connection and when you hit a large enough bump it cuts your power. Start it up and find a speed bump somewhere and drive over it enough to give your truck a jolt and see if it dies.

Posted on Nov 10, 2008

Ad

william moody

  • 713 Answers

SOURCE: 2003 dodge ram 1500, won't start, red security light flashes

more than likely in the interlock device i have known these things to mess with all kinds of systems on cars have it checked out to make sure everything is correctly connected and that they did not hook into the security system by accident.

Posted on Aug 30, 2009

Linh Thanh

  • 784 Answers

SOURCE: 1999 dodge ram le1500 pickup. starts easy but

You have fuel and spark, but the fuel : air ration needs to be at 14.6:1 ratio to have the engine running smoothly and efficiently. In order to have this golden ratio. Mass air flow sensor, O2 sensor needs to be synchronized well with throttle valve position to cooperate with the Engine Control Module. Try to clean off all gums built up in your throttle valve very well is the first thing to do before addressing next steps.

Posted on Sep 18, 2009

Anonymous

  • 460 Answers

SOURCE: I have a 93 dodge dakota,i'm trying to find the ground strap.

on some it goes from motor to firewall or motor to the frame.. you have to have a good eye for it is easily overlooked...good luck

Posted on Nov 17, 2009

Adman1

  • 1 Answer

SOURCE: 1996 Dodge Ram 1500 4x4 5.2L engine. Truck stalls

Hi, I have the same problem, I'm sorry I can't help, but if you figure it out please let me know.

Posted on Jul 11, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1999 Chevy G-30 utility van code p-0174 , cleaned then replaced MAFcleared code, back on 50 miles later, found vacum leak hose off vac. ball, code cleard 50 miles light back on,


what size engine do you have in the g-30 van. is it the plastic plenum. if it is there are rubber o-ring seals that go bad all the time and will cause the p0171,p0174,p0172,p0175 these are all lean codes also check for fuel pressure to make sure it is up to specs.
have you changed your fuel filter lately this can effect fuel trims.

Jan 09, 2012 | Chevrolet Cars & Trucks

1 Answer

My 99 vw passat is going out on me - tying to save its life - need to replace housing unit for new air filter - fuel pump fuel filter - will that solve the problem of... 1. every single time i put gas i...


With that many problems you should have gotten some error codes generated by your computer. Have you had your error codes read, so that you know where to start? While error codes usually won't take you to the exact problem they do put you in the general area of the problem.

When you replaced the fuel pump did you have good fuel pressure? Or did you not check it? While it does sound like a fuel problem, it could be in the spark system also. So the error codes are important to narrow it down.

Jul 06, 2011 | 1999 Volkswagen Passat

1 Answer

Showing check engine - then the code reader is p1133 and p0171


miles...?
P1135 Air-Fuel Sensor Heater Circuit Response.
the air fuel sensor malfunction is the main problem and thats causing the code p0171.
Hard to start o long cranking time to starter is gona be the first symtoms.
replace upstream. (the air fuel Sensor and the oxygen sensor is the same)

Mar 24, 2010 | 1998 Toyota Camry

1 Answer

My 1995 explorer has the check engine light on,


Try resetting the computer...by disconnecting the battery for 5 minutes. The codes should return in 50 miles or so of ormal driving.

If you have a factory radio, make sure you know the code to restart it.

Nov 11, 2009 | 1995 Ford Explorer

1 Answer

05 dodge diesel, code 0633, turns over but won,t start, what causes this.


That code will not cause it not to start. You got a fuel problem it sounds like. Try a little, a very little either. The injectors are **** on the common rails, lots of problems.

Oct 11, 2009 | 2005 Dodge Ram 2500 Truck

1 Answer

Transmission problems


I had a 01 impala that was **** too. switched to Ford and havent been to the shop since. If you look at the question breakdown for this website you will see 5 times as many posts for chevys than fords. However, you could have gotten a bad rebuild too. I had a rebuild done once and they boke most of the bolts that held the transmission in and didnt replace them.

Sep 30, 2009 | 2005 Chevrolet Impala

2 Answers

1997 bmw 740Il-116844 check engine code


How does the car start and run? If Ok, I would make sure the computer housing is properly grounded. Grounds are normally the problem when getting wacky readings.

I bet the car runs fine, Correct?

Good Luck

Mar 17, 2009 | 1997 BMW 318

1 Answer

93 eagle vision error code 51


the code 51 is your automatic shutdown relay control. and the crank position sensor is on the bellhousing behind the passenger side valve cover.
Have you replaced any relays? Let me know.

Jan 04, 2009 | 1993 Eagle Vision

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

51 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

85219 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...