Blower motor is not working on 2007 mitsubishi elipese

Usually, when the resistor goes bad it will still work at high speed! check the connector to make sure is making a good connection!

Could be. Older vehicles often had big resistors to control the fan speed. Modern vehicles like yours commonly have flat film resistor networks that are inserted into the air flow for cooling. Have a look for a cable connecting to the heat/AC plenums, behind the glovebox. If such a cable exists, see if there's a 1 or 2 screws that hold a flat film device. If its burned, it will be obvious.

Have you checked your blower relay in the under-hood relay / fuse block? I found a photo that may help you identify which it is. If the other relays in the block are the same type (all markings the same), you can swap one out for it to see if that fixes it before moving in deeper.

2004 Mitsubishi Endeavor AC transistor blower fix - YouTube

? 8:02
www.youtube.com/watch?v=6g_xozxuziE
Mar 19, 2015 - Uploaded by Peter Zafra
How to fix a Mitsubishi endeavor ac blower that stopped working. ... 2008 Mitsubishi Lancer HVAC Blower Motor Install How To - Duration: 9:07.

blower control module ( blower resistor) goes bad on all gm models it is located inside the car on passenger side of hvac case.

Need to check the blower motor resistor and the blower motor itself. They should be located under the passenger side dash.

Often times the problem is the blower resistor not the switch.
You would use a meter or a test light to check for power at the resistor and also the switch. The resistor controls power to the blower motor to adjust speed.

motor fan ac no work

The bower motor is most likely what you are smelling.Replace the blower motor,and the blower resister next to the blower motor if,the blower motor has no speeds.

Did you check the blower motor before installation?Check for a blown fuse,and a bad relay,also check the blower motor resister.I hope this was some help.