Pollen filter How to replace

Go here so you can find out how to replace and or clean the filter .
https://www.youtube.com/watch?v=8zFIRHp-NS courtesy of youtube . https://www.youtube.com/watch?v=8zFIRHp-NS

Hi Maria: Remove the glove box, then you will be able to remove the cabin air/pollen filter. If you need help removing the glove box, try You Tube and search "2009 Honda CRV dust and pollen filter replacement. You can purchase one from a Honda dealer online or aftermarket such as Rock Auto, etc. Take Care.

The filter will clean most of the pollen and other particles up. Just be sure to clean or replace the filter regularly. Some modern air conditioners will let you know when they think the s dirty and needs to be replaced usually located in the front if u have allergies id say wear a mask and if u talking about a car it's under dashboard u can't miss it

2010 Audi A6 240 PS

Pollen filters replacement:
1. Remove the interior trim.


2. Remove the cover.



3. Remove the second dust & pollen filter, then the first dust & pollen filter.



4. Clean the dust & pollen filter housing.
5. Refit all parts in reverse order of removal.

It's worth replacing both anyway the sensor is part number XRB58222 at about £5.00 and the Pollen filter C2S8622 priced betwwen £12 and £20 both are simple changes.

http://www.bluejag.co.uk/jaguar-pollen-filter-replacement.php

http://www.jaguarforum.co.uk/viewtopic.php?f=14&t=29437&start=0

in the end it may be you just need re gassing.

The pollen filters are located in the HVAC box behind the glove box. While holding the glove box open, unclip the glove box damper (left side). Then remove the glove box stops on each side, flip the glove box down. Pull the pollen filter housing from the blower unit by releasing the clips on both sides. Replace the filter in the housing make sure the arrows printed on the new filter are pointing down. Reinstall all removed parts. -hope this helps.

A LOT OF POLLEN FILTERS ARE LOCATED IN THE ENGINE COMPARTMENT JUST BELOW THE WINDSCREEN, NOT SURE WHICH SIDE, ALSO SOMETIMES UNDER THE COVER WHERE THE WINDSCREEN WIPERS ARE.

Dust and pollen filter, removing and installing
The filter is located in the right rear of the instrument panel under a cover.

Components of dust and pollen filter:




1 - Frame 3 - Filter element 4 - Plastic nut, 2.5 Nm (20 in lb ) 5 - Filter housing with seal Removing

• Push center cover -1- forward -arrow A- and lift up to remove.

• Remove screws -arrows-.
• Lift right plenum panel cover -1- and remove from clips at front and rear edge.
• Pull cover -1- toward center of vehicle and out of retainer in A-pillar to remove.

• Remove screws -arrows- and remove right closeout panel -1-.

• Remove rubber grommet -1-.
• Press tabs of filter housing in direction of -arrow-.
• Remove filter element with frame in upward direction -arrow A-.

Installing

• Guide frame -1- into first slot on left and right sides of new filter element.
• Press frame with filter into housing -2- and engage retainers.