The remote control only operates the drivers door lock. The drivers door switch only operates that door.
The front passenger door switch only operates the the drivers door lock.
The automatic locking system triggered by vehicle road speed only operates the drivers door lock.
The tailgate can only be locked/unlocked by climbing over the back seats.
This problem used to be intermittent but has now become permanent
Unlock all of the Jeep Grand Cherokee's doors and open the driver's side door. Keeping the door open, lock it using the manual lock on the door itself.
Put the manual key into the ignition and switch it to the "On" or "Run" position, whichever applicable, without starting the engine.
Control any distant PC remotely. Test the Software now for Free!
www.TeamViewer.com/Remote_Control
Point the remote at the receiver (located by the little bulb on the car ceiling) and hold down the "Lock" button for up to 5 seconds.
When the driver's side door unlocks, you know the remote has been programmed correctly. If you are only programming one remote, jump to the next step. If not, manually re-lock the driver's side door and repeat steps 5 and 6 using each remote you would like to program and then continue.
Turn the key to the "Off" position and turn the ignition on immediately. This must be done within 20 seconds of programming the last remote. You're finished!
1,255 views
Usually answered in minutes!
remote locks and unlocks doors but will not turwith
×