Pcm vibe 03 locstion - Frontier Nissan Cars & Trucks

Kill switch for what ? Fuel pump ? If so . doesn't have one . There is a circuit opening relay in the I/P fuse box >The relay is energized by the PCM - engine computer . Do you know what a relay is and how it works ? There are video's on youtube on testing relay's and the electrical circuits they control .

P0606 , P0607 ! no such codes P06006 or P06007
DTC P0601, P0602, P0603, P0604, P0605, P0606, P0607, P1600, P1621, P1627, P1680, P1681, P1683, or P2610
DTC P0606 Control Module Internal Performance
The DTC P0606 and P2610 set when the powertrain control module (PCM) has determined that the control module has an internal fault. The PCM performs continuous self checks of all internal circuits. There are 2 central processing units (CPU) within the control module. If the outputs from the two CPUs deviates from the standard level, a DTC P0606 sets. The control module has several internal clock or timer circuits. The DTC P2610 diagnostic monitors the internal timer circuit responsible for the ignition OFF operation of the evaporative emission (EVAP) system vacuum leak pump. If the there is an error in the control module timer, a DTC P2610 sets.

Is it charging properly should be at least 13.8 to 15.2 volts and amperage should max out at approx the alternators rating with full load.

contact GM dealer they will tell you if yes or not but have your VIN ready Vehicule Identification Number
hope it help

ac clutch relay; $11 at rockauto.com

The new PCM on these has to be programmed either by the people that built it or by someone who has the capability to reprogram it [usually a dealership]. The computer can be programmed before it is installed and usually they'll need the VIN#, mileage, etc to do this properly. I don't believe the vehicle will run if you put in an unprogrammed PCM. It's very rare for one of these PCM's to fail so make sure that you haven't overlooked some other problem that is mimicing a bad ECM before ordering one as they are quite expensive.

hi this is located on the right hand side of the engine on top of the transmission, the best way to locate it is to follow the + lead from the battery and on the end of that will be the starter motor....hope this helps

the axles are held into the trans with internal "SIR" clips, they just pull out, you need to pull straight out in a quick snapping motion, they can be very difficult to remove

we had the computer code p2716 on our 2005 pontiac vibe -shift solenoid. gm says to replace the pcm before you do anything else.  we tried this and it works.

If you have a PCM problem it will be covered under the 8yr fed warranty if you have under 80,000 miles. Take it to a dealer