Gears do go in but my truck cant move

Question edited for clarity full make model.
Question moved to make model category.

Mercedes Benz Fault Codes

Classtrucks.com https://www.classtrucks.com > buyers-guide > mercede... This page covers the most significant information you need to know about Actros truck fault codes, including common codes, their meanings, and methods of fixing

Mercedes Actros GS Fault Codes

Truckmanualshub.com https://truckmanualshub.com > mercedes-actros-gs-fau... List of Gear Shift Fault Codes (GS) for Mercedes-Benz Actros, Axor, Atego; MB Error Codes.

Fault Code List For Base Module (GM) Control Unit 1 ' PDF

Scribd https://www.scribd.com > document > Fault-Code-List-fo... 5643 Windshield washer pump motor has Short circuit to positive. 5644 Windshield washer pump motor has Open circuit. 5742 Headlamp washer pump motor has Short ...
Rating: 5 · ‎ 2 votes

The 3344 2017 model experiences a gear engagement issue when coming to a dead stop, required the driver to switch off the truck before gears can engage properly again. Fault codes GS22, GS24, and GS28 are present.

I DON'T KNOW. PLEASE CHECK [WITH ENGINE RUNNING] IF THE FLUID LEVEL IS CORRECT.

Hello

The engine and the automatic transmission (transmission control is only for automatics, engine is still computer controlled no matter the transmission type) in this vehicle are computer controlled and in most cases when a fault occurs a fault code is stored in the memory of the computer control module. There are exception to this, such as the Mass Airflow Meter and fuel pressure problems. What must be done is to have all the basic testing done such as a scan of the system for fault codes as well as a check with a live data scanner tool for engine functions that are not within range of normal, a trained technician is required to know what is correct and what isn't, then based on careful diagnostics done from a factory repair manual the correct part is replaced or the wiring repaired or the computer replaced (known as the PCM), which is very rarely the problem. Other basic checks must be done as well such as mechanical problems with the engine as well as engine state of tune and mileage on the engine. The transmission can have mechanical issues as well such as no gear engagement at all or a failed pump or other pressure related problems.

Hi there:
When you say it will not shift into gear, do you mean the shifter doesn't move out of the park position or the shifter moves into the gear ranges but the trans doesn't engage and move the car.



First I suggest checked the fluid level, is it full or low or maybe high, check it with the engine running,


Could be a problem with the torque converter or valve solenoids.

Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

You need to adjust the 4x4 shifter itself. That's your only problem. Moving the shifter isn't putting the transfer case into gear and speedo will move, whirring sound is just the bearings spinning. Re-set the 4x4 shifter linkage to proper specs.

you check the ATF (trans oil) condition this good indiccator for your trans status . (burn mean clutch inside burn ) have small chips . change ATF and filter and make sure it;s in level.

Failure of the Auto clutch or a fault in the transmission box. In both the cases the gear box/trans mission must be checked.
Check the activation of the gear stick to ensure that the requested action is seen on the box or is a failure of the link or electrics.

I am having the same problem. Gear shift will move freely, but will not come out of park. Any solution to this?