Location low pressure port a/c 2000 ford ranger 3.0

On top of AC Accumulator

hmm ..if you are looking for the low side air conditioner port .. then locate the condenser (thats in front of and looks like the radiator) .. you will notice two tubes going to that ..one is large the other small .. the small tube is the high pressure side .. the large tube is the low pressure side ... follow the large tube back until you find a cap that covers the low pressure port .. thats where you would fill with new refregerant (r134a) .. if you buy r134a, you can also get a filler hose and gage.. that hose will only hook up to the low pressure port ..it wont fit the high pressure port ...

Below the pass. headlight. look underneath bumper to find it

The low pressure service gauge port valve is located on the A/C manifold and tube. please rate, thx

Go to your closest ford dealer and ask if they have a book showing all the parts and lay outs of your vehicle, or even try e-bay or a book store. But Ford should be able to help you.

Wayne

im assuming your talking about the a/c low pressure port? it should be on the receiver/drier(steel can with 2 lines hooked to it) or in the lines connecting to it

please rate as fixed if this helps you.

The low pressure service gauge port valve is located on the evaporator to accumulator/drier suction line.


The evaporator to accumulator/drier suction line contains low pressure refrigerant gas and is equipped with a serviceable low pressure A/C charge valve port.

Your service port will always be in the larger line of the two .. which is low pressure side. It might be in the dryer also which is low side.. your dryer is about 3 inches across and 8 inches long and also has your pressure switch for the AC compressor in it.. holler if you dont find it now... thanks Jerry

look for lo and hi on the cap.
please see this layout diagram... and you can trace it down yourself.


The lines coming on the dryer canister are HI side.
Use the opposite one to charge.

Thanks for using FixYa - aFixYa rating is appreciated for answering your FREE question

The egr valve has two sensors. One is an EGR position sensor which is physically attached to the EGR valve. The other sensor is the DPFE (Delta Pressure Feedback EGR) sensor, commonly called the EGR pressure sensor. It's location varies depending on the engine you have. You can fine this sensor by following the vacuum hose on the EGR valve. It will be with in inches of the EGR valve. The sensor will be black (plastic) or silver (metal), have two or three vacuum ports and an electrical connection on it.

The vacuum pressure sensor is a high failure item on fords. Any Ford parts department will have one in stock, as well as some aftermarket parts stores.

The new sensor may not look exactly the same as the old part, but will have all the hook ups as the old one. You may also need to replace the vacuum hose to the sensor as well