I just washed my explorer and when i got home i noticed both brake lights and 3rd brake light where on but very very DIM. lights where turned off and ignition was off.just to check i pulled the fuses for break, & SW they did not shut off tried pulling some other fuses, still nothing. So i pulled the 60amp fuse for the fuse box thy still stayed on.So i pulled out both taillights no water pulled on some wires they are still on i am getting 1.14VDC through the break lights i have know idea.So i gave up disconnected the battery last night still doing it today???? please help!!!!!
Is that volts with the plug connected sounds like either a ground at lites or brake lite switch under dash, try making your own ground
at tailite, wayne
SOURCE: brake lights stay on all the time
check the brake light switch at the top of the brake pedal and if you have a keyless enter keypad on the door check that for shorts and go through the car and make sure nothing is left on
SOURCE: Last night the climate control
have the programmer checked that runs off the control head that flashes. Most likely that item is at fault
SOURCE: wipers will not turn off
Your wiper relay contacts are stuck. The wiper relay is located INSIDE the wiper motor assembly. You must replace the entire wiper motor assembly to replace the relay.
You might try rapping on the wiper motor with a small hammer or a screwdriver handle a couple times to see if you can jar it loose.
642 views
Usually answered in minutes!
×