I have a motor from a 1998 chevy s10 want to make sure it will fit in a 1999 chevy s10
SOURCE: Heater 1998 chevy s10
wide open hung thermostat can cause this too...continual circulation never allows the water to get hot enough to warm the heater core
SOURCE: 1998 Chevy S10 front axle will not engage when put into 4 wheel
Normal thing that happens as long as onone (worked) on it, is the vacume hose going to the engage sevevo under the battery box has fell of on either end or is brocken on the way there. Then the once or now leaky battery acid ate up this same servo. then the cable going to the front axel breaks sticks falls off or even someone needing one climbed under your truck while parked somewhere to get one to replace their brokeen one now you don't have one then theaxel engage arm or gearset is damaged
SOURCE: Installing a blower motor in a 98 Chevy Blazer
96 chevy S10 p/u truck 4cyl 2.2 liter
shift solenoid electrical problem
SOURCE: firing order for a 1999 chevy s10 pickup
I apologize for the late response...Due to the bad economic situation this site has had a substantial (+50%) increase in the number of questions being asked in the last four months.
I assume you have a 4.3L and not the 2.2L?
For the 4.3L:
Firing Order:
1-6-5-4-3-2
Cylinders:
6-----------5
4-----------3
2-----------1
(front of vehicle)
Distributor:
coil wire-->
-----6------->............<--------5-------
-----4------->............<--------1-------
-----2------->............<--------3-------
............(front of vehicle)
Let me know if this helped, or if you have additional information or questions. Feel free to contact me at FixYa.com!
419 views
Usually answered in minutes!
×