I need to know how to install a blower motor on a 1993 Dodge Dakota.
SOURCE: 95 dodge dakota heater blower not working
It has been a long time since I've replaced one of those. From what I remember you don't have to go through pulling the heater box out. You do need to remove the glove box assembly. Look up under the passenger side of the dash. If you see the bulge of the motor/cover hanging straight down then remove the cover and the motor will be there. If you don't see that then te motor is mounted horizonally. If that is the case then the fresh air door assembly will need to be removed and it is behind that.
Here is a quick check to see if the motor is bad. Thump the bottom of the heater box by the passenger's feet. if the motor comes alive or makes noise then it is bad. Also check the fuse and make sure that it doesn't work on any speed. (the resistor would prevent operation on only one speed or more but generally not all speeds)
SOURCE: How do you install a window regulator for a 2001 dodge dakota?
well first take off the door panel it shouldnt be hard remove plastic cover off door.Make sure your window is all the ways up before you remove the motor.you can hold it up with duct tape or anything similar.Then remove the screw that go to the regulator sometimes it has rivets wich have to be drilled off.The new regulator should come with screws if it has rivets if not u use the same old screws.Also unplug the harness of it . Install new one,screw it on and reverse the procedure.Any problems keep me posted
SOURCE: 2002 DODGE DAKOTA, BLOWER MOTOR QUIT, CHECKED
if u changed all of that then it should be the heater control . have u given direct power to the blower motor? it is possible that its faulty.
SOURCE: 2006 dodge ram 2500 diesel ac damper above blower
2006 dodge 2500 diesel. low voltage at compressor.
85 views
Usually answered in minutes!
×