Tried to enter radio code, but not sure what to press for it to accept the code. The display just sits there with the code.
SOURCE: unlock radio in 98 beetle
I've had this happen twice when the battery died. It goes into the SAFE 2 mode if you try entering it and don't do it right and then you have to leave the radio on for 1 1/2 hours to have it come on to 1000 and then set it with each number one at a time and then hold down right reset until he beeps on. So, if you are discouraged as I was, the answer is to leave it on with the SAFE showing for over an hour and it probably will come on with the 1000 for setting eventually.
SOURCE: Problem with entering anti-theft radio code for
when you use the "preset keys" (the keys on the radio with numbers on them) to enter the code, each time you press a code number, a letter appears [c, o, d, e]. once the word is spelled out, from entering the correct 5 digits, the radio is reset, ready to go.
BUT if you miss a number, enter a wrong number, whatever, each number pressed, still makes a letter appear from the word "code". once the word is spelled out, by entering ANY 5 numbers, if ANY of the 5 is wrong, the radio displays a message "Error" and then a number 1 thru 10.
When you see the word "Error..."
the next preset button you push, starts the whole thing over again. The radio says "Enter code". That is when you enter the 1st of the 5 digits, the letter C appears, enter the next digit, the letter O appears, enter the next digit, the letter D appears, enter the last digit, the letter E apperas, the radio is reset, ready to go, if you got the 5 correct numbers entered.
you have 10 chances to enter the right 5 digit code. Each wrong try of 5 digits yeilds a display of "Error 1", "Error 2", "Error 3", etc 'till you get to 10 incorrect tries of 5 digits each.
If you dont get it right in 10 tries, you have to leave the radio "on" for an hour, then it will let you start the 10 tries over again.
Good luck!
SOURCE: Nissan stereo sy702 with constant err flashing after flat battery
WRONG! Leave the radio on for 1 hour using the key and accessories to reset then enter the pin. You get the pin from nissan customer service in your area but you need to supply your vin/chassis number.
To enter the pin you press buttons 1-4 corresponding to the number of the pin eg. pin is 1023, press button 1 once, 2 ten times, 3 two times, 4 three times
If you have the security code it's easy. The code is something that either you or a previous owner entered. If you don't have the security code a trip to the dealer will be in your future.
Unlocking the Theft-Deterrent Feature After a Power Loss
Enter the code as follows; pause no more than 15 seconds between steps.
Entering the incorrect code eight times will cause INOP to appear on the display. Wait an hour with the ignition in the ON position before you try again. When you try again, you will have three more chances (eight tries per chance) to enter the correct code before INOP appears.
Deactivating the Theft-Deterrent Feature
Enter the code as follows; pause no more than 15 seconds between steps.
Entering the incorrect code will cause SEC to appear on the display. The radio will remain secured until the correct code is entered.
700 views
Usually answered in minutes!
×