Question about 2003 Dodge Neon

Open Question

Engine vibration when it is in a forward or reverse at idle

Posted by Anonymous on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Diagnois ford territory engine mount vibration


u can do this 2 ways.tranny mounts, have someone get in the car,holdbreak,put in gear,slightly ascelarate the throttle and watch the engine .in drive engine will travel forward and vise versa in reverse.believe me, if u have any bad u will think the motor is tryin to jump out. upper mount check/ 9 out of 10 times,it feels like u are in a popcorn machine when u come to a complete stop ildeing in gear, take a small floorjack and place it under the oilpan again have someone in the car . start and put in gear, just let it idle,and slightly raise just the motor and see if the vibration goes away ./ note,be sure to have a small piece of wood between jack an oilpan.

Feb 04, 2015 | 2006 Ford Territory 4.0

1 Answer

Vibration at idle


CHECK THE ENGINE MOUNTS . THEY TEND TO LOOSE FLUID AND WEAKEN!!!LET ME KNOW

Feb 19, 2014 | 2003 Volkswagen Passat

1 Answer

Engine vibrating


Are the transmission mounts good also? You can check them with a pry bar and stretch them to see if theyre broken or the rubber in the center is torn, or have an assistant start the vehicle and and put in gear and hold the brake and give it some throttle and observe the mounts under the hood to see if the engine has alot of movement in forward and reverse engagement. Also,check to see if idle is at factory setting.If (TPS)(throttle position sensor) is to low then it WILL also cause a vibration.

Jan 01, 2014 | Daihatsu Cars & Trucks

1 Answer

Bad front end vibration while in gear at idle only makes dash and floorboard vibrate


When you are in gear at idle with your foot on the clutch you have placed an axial load on the crank which is pushed forward in the main bearings against a thrust bearing. I suspect a failing thrust face on this bearing as it only works under a clutch release load. The only other point that is under load is the clutch throw out bearing but if that is failing you should be hearing a tinny type of rattle when you have the foot on the clutch

May 05, 2013 | Mitsubishi Galant Cars & Trucks

2 Answers

Low RPM and Vibration in First Gear


Possible dirty throttle valve and idle speed control valve.

Throttle Body Cleaning on vehicles without electronic throttle control (most 2003 and down)

You can in most cases repair this slow speed stall or unstable idle by cleaning the engine throttle valve and the idle speed control valve using a product called CRC Spray Throttle valve cleaner. Spray the cleaner into the air intake of the engine with the hose removed from the throttle body, the engine will try to stall so hold up the idle speed manually. Once you have used up about 1/2 can of the cleaner stall the engine out while spraying and turn the key off, disconnect the negative battery cable for 5 minutes and then reconnect and drive the car for a about 25 miles of varied driving modes. If this doesn't cure the problem you may need the fuel injectors professionally cleaned by the dealer service dept.

Jul 13, 2017 | 2002 Mitsubishi Galant

1 Answer

My 2003 Ford Focus started making a grinding noise when in reverse and in right turns. After driving about 20 miles the symptoms disappeared. The symptoms have gotten progressively worse, vibration and...


Check the front engine mount..If its bad it could make a noise while turning or reverse..Hold the car in gear with your foot on the brake and carefully raise the engine ..do it in both reverse or forward and look for excessive movement..

Sep 22, 2011 | 2003 Ford Focus

1 Answer

Check engine light w/ vibration on turns


yes please pull codes your engine is probably missing and thats what your vibration is

Dec 10, 2009 | 2004 Chrysler Town & Country

1 Answer

2002 Dodge Grand Caravan, 69k miles, vibration at idle in D


check the motor motor mounts for movement,
watch how far engine rocks forward or back with it running and foot on brake

Dec 02, 2009 | 2002 Dodge Grand Caravan

2 Answers

My 2001 MB E320 vibrates when in drive and at idle. The engine runs fine. It does not vibrate in reverse at idle. What causes this strong vibration?


hello,good day,seem you have problem on ignition or fuel system,maybe one spark plug or nozzle need replacement,or better to send your car to a dealer for proper diagnose,ty

Nov 26, 2009 | 1999 Mercedes-Benz E-Class

1 Answer

Vibration when using reverse gear .when shifting to reverse gear i feel vibration like oil pump vibration


Have your motor mounts checked very soon. This only shows in reverse because reverse causes a backward torque than the engine does in forward gear.

Sep 13, 2009 | 2001 Jeep Grand Cherokee

Not finding what you are looking for?
2003 Dodge Neon Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...