SOURCE: Radio code for Acura Integra
Well, ive solved my own radio problem LoLz! On my 1996 Acura Integra LS-S the serial number is located on the back of the radio. The dealership told me to bring it in and they will remove my radio for $9O. That's ridiculous.If you can remove it yourself then you save ninety dollars. Or just do what i did...I squeezed my lil a** under the steering wheel and peeked behind the indash thingy where the radio is held and with a flashlight i was just barely able to see the serial number. I dont know if the serial numbers are all the same for all the makes, models and years like mine. But heres what i got. The serial number is: PH22481 the code for the radio is 26162. I called my local Honda dealer and gave the serial number and they gave me the code over the phone. If it doesnt work try disconnecting the battery for about 6O seconds and try again. Good luck and i hope this helps. FOR I FINALLY HAVE MUSIC!!!! YAY!!!
SOURCE: Main relay location
The main relay is located behind left side of the dash and above and behind the fusebox and above the hood release.
rate this solution fixya.
Diagram below:-
Acura Main Relay location and removal procedures.
Integra
EFI Main Relay for:
The main relay is located behind left side of the dash and above and
behind the fusebox and above the hood release. The First generation
Legend main relay location is between the steering column and the fuse
box. It's deep in there. There was a little difficulty drawing the
relay so it's actually very deep in there. There is a device (a relay)
blocking
the main relay. You will need to remove it to get a view of the main
relay. The removal procedure is the about the same as the Accord's
procedure.
Legend, 96-98 Acura TL main relay
Acura Integra 98-01 main relay location:
Locating the main relay using your ears and fingers:
Steps:
1. Turn the ignition to ON. You should hear two clicks (a thousand
of a second apart) under the left or right side of the dash board. One
click is for the ECU/Injectors the other is for the fuel pump. At this
moment the check engine light should come on.
2. Listen carefully at the moment the clicks engage (usually somewhere
underneath the dashboard.) Reach in and touch the main relay.
3. 2 seconds later you should feel a click if the main relay is at
least working or wait until it works. At this moment the check engine
light should go out.
4. Turn the ignition to start and you should feel a click, turn engine off you should feel another click.
5. Most main relays should have seven terminals. Please check if the location is already listed below.
How do I get the main relay out?
Steps: See four ways below so you can get it out. First you have to reach
high up in there and do all this with one hand and a flashlight.
A. Unbolt the bolt using a 10mm socket (picture A) or
Ab. Unclip the clip from the steel tab and slide it apart (picture A) or
B. Separate the steel tab from the plastic case (picture B) with a
large flat screw driver
jam and twist between the plastic case and the tab or
C. Disconnect the negative battery terminal. Unclip two clips I pointed with two arrows (picture C, or below)
with a small flat head screw driver or with a strong thumb and then yank it out (D.)
This is the preferred choice by many. Mechanics prefer choice A and maybe
B. See detailed relay circuit photo.
SOURCE: what is the firing order for a 93 acura integra ls
For the 1.7L VTEC DOHC AND the 1.8L DOHC:
Firing Order:
1-3-4-2
Cylinders:
........(back)
4------3------2------1
.......(front)
Distributor:
....(back)
...1
.............3
2
..........4
...(front)
Rotation:
Clockwise
Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!
245 views
Usually answered in minutes!
×