Question about Cars & Trucks

1 Answer

Trying to find location of crank angle sensor on a 2007 mitsubishi outlander 2.4l engine

2006 Mitsubishi outlander 2.4lt engine with timing chain, trying to find the location on the engine for the crank angle sensor

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Cars & Trucks Master
  • 443 Answers

Inside timing belt cover trying to find location of crank angle sensor on a - 6b14afea-b28b-4e51-b5a2-bb40a4e795d8.jpg

Posted on Mar 04, 2014

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 362 Answers

SOURCE: Cam Belt on Outlander 2.4 litre Petrol - 2004

The vehicle has a belt and should be changed every 60,000 miles.

Posted on Jan 31, 2009

Roger Foster

  • 701 Answers

SOURCE: need location of crank angle sensor on 1997 pontiac sunfire 2.2 liter

Hello oldiro: My name is Roger and I can help. From under the vehicle look up between the transmission and the side of the block. Mid motor above the pan rail there is a bolted in sensor. This should be the crank sensor.It will have two wires plugged in to it. Please rate this answer as this lets us know you received the information you asked for. Should you need further help please just ask. Thank You for using FixYa. Roger

Posted on May 06, 2009

localwonder

Michael Masters

  • 6784 Answers

SOURCE: crank angle sensor location

The crank sensor is always located next to the crankshaft pulley. it will be inserted into the block with the top part of the housing half way out. you cant miss the wires leading into the tip of the housing next to the crank shaft pulley.

Posted on May 23, 2009

Superbovine

  • 333 Answers

SOURCE: mitsubishi outlander cooling fans not operating

There is a Recall to replace your cooling fan module because of this concern.

Open your hood and look at the black box bolted to your radiator fan by the battery. If it does not have a green dot on it, you have not had the replacement fan module installed.

Contact your local dealer with your VIN handy to verify the recall has not been done and to schedule an appointment.

If the recall has been done, verify if you have power coming out of the module to the fans, as the fans do burn out eventually.... but rarely both at once.

Posted on Sep 10, 2009

masterase

  • 226 Answers

SOURCE: What are the best tires suitable 07 Outlander XLS

www.tirerack.com They have a great setup on deciding which tires you want with a ton of information.

Posted on Nov 18, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the crank sensor located on a 2003 Mitsubishi


Remove the lower timing belt cover.
Remove timing belt cover bracket.
Remove crank sensor.

Jan 02, 2015 | 2003 Mitsubishi Outlander

1 Answer

2003 mitsubishi outlander died at stop light. wont start. turns over and has a full tank of gas. is getting fuel to engine.


very poss it could be crank sensor ,broken wire ? timing belt? advise installing scan tool that reads live data check eng rpm on scan tool see if shows eng rpm while cranking , poss remove upper timing belt cover make sure is turning and not damaged, poss computer related problem or power to eng systems would have to check for power at fuel injs and check for ground pulse with logic probe or led test light if crank sensor ok also check for spark at plugs with special plug tester and check codes first

Sep 14, 2010 | 2003 Mitsubishi Outlander

1 Answer

How to r&r headlight switch on 2007 mitsubishi outlander


Remove the clamshell cover from the column (philips screws)

Press together on the top and bottom levers on the headlight switch base and pull outward.

Jul 17, 2009 | 2006 Mitsubishi Outlander

1 Answer

Where is the cabin filter located on a 2007 Outlander


Cabin air filter is located behind the glove box. Glove box removal required.

Jul 10, 2009 | 2006 Mitsubishi Outlander

1 Answer

2003 Mitsubishi Outlander died and won't start back up


If it does turn over but won't start, check for fuel and spark, if not spark then check to see if the crank sensor is cover with dirt.....

Feb 09, 2009 | 2003 Mitsubishi Outlander

1 Answer

Cam Belt on Outlander 2.4 litre Petrol - 2004


The vehicle has a belt and should be changed every 60,000 miles.

Dec 08, 2008 | 2004 Mitsubishi Outlander

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

1,147 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

Marvin
Marvin

Level 3 Expert

85216 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

john h

Level 3 Expert

22486 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...