I dont think the motor is blown because i do not hear a clicking or humming sound when i push the button. The window has shown no problems with going up and down, it seems to be at a good speed when doing either. It all of a sudden just will not move.
SOURCE: 2001 gmc sierra power window
YES THE SWITCH IS BAD SINCE IT RECEIVES THE MOST USE DURNING OPERATION ESPECIALLY THE DRIVERS DOOR REPLACE THE SWITCH AND IT SHOULD WORK FINE
SOURCE: 2000 GMC Jimmy SLE driver's power window
I had the same problem...it was the window gear that got stuck when the window was all the way up. (that's the clicking) I took my panel off and banged on the inside of the door with a rubber mallet. The window works again. Since then I make sure when I role the window all the way up to stop that I just barely tap the down button to release the pressure on the gear inside. When your using the hammer...hold the switch in the down mode...ignition on of course.
SOURCE: 2000 GMC Jimmy SLE driver's power window
The same thing happened to my 1999 JMC Jimmy recently. I believe the problem is that your power window motor has most likely gone out or is starting to go out. The motor will need replaced. They are pretty expensive new. I went to a junkyard and got one for around 15 dollars. When mine went bad, I had rolled my window down about three or four inches and it stuck there. I took my door panel off and tapped on the motor while holding up on the window switch and got it to go up after a few minutes. I am replacing my motor today, I'll leave an update here about the outcome when I finish the job. I hope this information helps you.
SOURCE: HAVE A 03 GMC SIERRA
I had the same problem in my wife's 2003 Yukon Denali. The power seats and passengers side window wouldn't work. Turned out to be a blown Buss Type fuse in the Underhood Fuse Block. It is the one marked MBEC 1 50amp. Hard to tell if the are blown so look very carefully. Should look like a hoop with two shiny solderlooking bubbles on either side. On my blown fuse, it caught my attention because it looked like the solder was missing and I had to look very closely to see the bottom of the "hoop" was open. They are very hard to remove and must be pulled straight up.
This type of fuse looks like a red square with a clear plastic top showing the fuse link under the plastic. On my vehicle it is on the top row second one from the left.
SOURCE: 2001 GMC Sierra Power Window problem
you should check the wire harness that goes from the door to the truck there must be a bad conection near by there somewhere in the harness hope this could help you.
1,081 views
Usually answered in minutes!
×