Tail lights work only , no brake light including back window brake light, turn signals , or hazards work on rear of vehicle
Sounds like a wiring loom connector may have come apart as affecting all rear lighting trace loom back from light cluster to see if all are connected properly
Where is the wiring loom connector located?
the wiring loom(s) will be located behind the side panels in the rear of the vehicle , gain access to each rear light cluster from rear , as though you were changing a bulb, then trace where the wiring goes and when you get to a connector make sure it is pushed fully home , it would also be a good idea to check for power at the same time with a volt meter whilst having some one operate the affected lights, if you have power then it must be a component fault, hope this helps
×
SOURCE: Hazard Lights Won't Work on 96 Taurus
FIRST Check for Blown Fuse Then Locate Flasher Units @ Fuse Block to Determine Wiitch one is Hazard Turn On Key Then Turn Syg. Feel Flashers The One you feel Clicking is For Turn The Other IS Flasher Replace this Flasher unit.
+
15 (10 A)
+
29 (15 A)
SOURCE: 2002 ford taurus tail lights are not
You have a bad connector or wire. Use a multimeter to check the wire and connectors from both lights. My bet is on the wire.
Go the cheapest way first..... Replace both bulbs. It may be that both bulbs went out relatively at the same time
602 views
Usually answered in minutes!
×