How do you remove and alternator from a 1996 Dodge Caravan
SOURCE: tensioner pulley 1995 dodge caravan
Hi my name is Allen!
To help you I need to know what engine you have?
For example; 3.0 liter or 3.3 liter
If it is the 3.0 liter the nut for the tensioner is toward the firewall side of the engine tucked tightly under the exhaust manifold, very hard to get too.
If its the 3.3 liter you would have already seen it, both have only one nut holding the tensioner on. This one is easier.
For further assistance contact me at FixYa!
SOURCE: dodge caravan sliding doors
First, keep in mind that as you begin to remove these doors you run the risk of causing serious scratches to the paint and glass, so put some masking tape and/or plastic sheeting around both sides of the door (rear quarter panel and rear glass, front door and front door glass)
I would get a Haynes repair guide since that's what I have to work from and it will tell you step by step with pictures, what to do. It's not hard, but you need to get all of the attach points unhooked to be successful. Suggest you have a helper working with you to keep the door steady.
SOURCE: hoe to Replace an alternator on a 1996 Dodge Ram Van 2500 3.9L V6
Remove negative battery cable.
Remove the electrical plug and wireing. Mark them.
Loosen the alternator pivot bolt.
Remove the bolt that attaches the alternator to the adjustment arm.
Rotate the alternator to loosen the drive belt and disengage the belt from the pulley. Be careful that any spacers that are used in mounting are kept with their original bolts. This will make correct reinstallation much easier.
While supporting the alternator remove the pivot bolt.
Remove the alternator from the vehicle.
Do the reverse procedure to install new alternator.
SOURCE: I can not figure out how to remove the alternator
I have recently done this twice to my 2000 Grand Caravan with the 3.3l engine.
1) Remove the top plate which is attached to the alternator mounting bracket held in by 3 bolts.
2) remove the alternator bolts securing the altenator to the mounting bracket.
3) pry the alternator off the bottom mounting bracket
4) turn the alternator around show you can easily see the power wires on back of the alternator and remove the 11/32 nut holding the wire to the alternator. Be careful not to drop the nut behind the engine, because you probably will never find it (experienced).
5) Disconnect the wires from the alternator
6) Remove the black cooragated tube running vertical in front of the alternator and remove the tubes hold clip from the suspension wall.
7) Slide the alrernator pully first up through the opening. You may need to rotate the alternator a little so it fits up through.
Chris
SOURCE: locate bolts to remove the strater of 1996 dodge caravan
Almost all starters have ears with holds in them that bolts go through to threaded holes in the bell housing. Find the starter and look around the end without the wires for the bolts.
181 views
Usually answered in minutes!
×