SOURCE: 2000 f250 super duty coil#4
Many times a bad plug will cause the coil coded to be dropped. If you have not changed them be sure you change all of them (8 or 10)
SOURCE: 2003 ford f250 super duty 7.3ltr I switch it from
Hi,
The wiring from your overdrive cancel (or tow/haul) switch is shorting in your steering column. Remove the plastic trim from around the steering column. From above the steering column look in the area where the gear shift meets the column. You will see a pair of wires (twisted) wrapped in a black tube. Examine these wires really closely and I am sure you will find an area where they have rubbed thru. Wrap a little electrical tape tightly around the area and you are good to go. To get the top plastic piece off of the column you may need to remove the ignition key cylinder. turn the key to the run position. Under the cylinder on the column is a small hole. Push a pick into the hole while you wiggle and pull outward on the key cylinder. The cylinder should pull out and allow you to remove the plastic trim. The cylinder must be in the run position when you reinstall it too.
I hope I was descriptive enough. I hope this helps you out!
SOURCE: My 2008 F-250 Super Duty
on driver side of t case pull actuater spra with pb blaster turn 4x4 off and on it will break loose then put it back if noyt turn shaft with chanel locks and buy a new one bout a100 bucks
253 views
Usually answered in minutes!
×