SOURCE: 1994 honda accord
The D4 light blinking indicates there is a diagnostic trouble code stored.When a malfunction occurs,the vehicle computer records the code and stores it,then flashes the D4 light to let you KNOW there is a problem.On pre OBD 2 Honda vehicles,1995 and back,Hondas are manual code read,which means you do NOT hook up a scan tool as there is no scan port.The passenger side front kick panel is removed,and a blue 2 wire connector located.Use a jumper wire to short out the connector,then turn the ignition key on,with engine off,not running.This throws the computer into self diagnostic mode,and the D4 or "s" light will flash a series of flashes.The flashes have to be counted,and written down.For example,2 flashes followed by 4 flashes would be a code 24.The code is then looked up with reference material for a description and diagnostic route.Every diagnostic trouble code,has a diagnostic route,for repairing the problem.Again,this informtion,the diagnostic route,is available in reference material from pay sources like All Data Online.After the repair is made,the battery is disconnected to clear the code.Good luck.
SOURCE: light around "D4" transmission indicator is blinking
this indicate a transm. failure, begin to check fluid transm. level.
SOURCE: D4 blinking, spedometer not working, check engine light on
Hi, a few questions 1st. Did your mechanic check for engine codes? Is your Honda a v-6 or 4 cylinder?
The flashing D4 light indicates a possible transmission malfunction. You should avoid rapid acceleration until the cause of the light blinking is determined.
If you have the V-6, there is a diagnostic port to connect a scan tool to read any stored engine codes that have turned on the check engine light. This port is located behind the ashtray in the center console (most cars did not have this til 96).
If you have the 4 cyl engine, there is a service connector located under the dash on the pass. side. Inside the connector is what looks like a 2 wire plug should be attached. Take a paper clip, unbend it, and insert the 2 ends of the clip into the connector to 'jump' it. Turn the ignition switch to the on position (don't start the vehicle), and the check engine light will flash. Count the flashes, short flashes are for code #'s 1 to 9 (single digit code), a 2 digit code will be a long flash for the 1st digit, followed by a short flash for the 2nd digit. If there is more than one code, they will be separated by a pause. They will repeat so you can count them and write them down. Let me know what the code #'s are so I can help further. Curt
SOURCE: My D4 light is blinking
The blinking D4 light indicates a transmission problem. If someone installed the trans and engine for you, bring it back to them to determine what the problem is, as it should be under some type of warranty hopefully. If you did the swap yourself, I would scan for codes (free service at parts stores) to see if any come up. Last, you could try disconnecting the neg. battery cable for about 10 minutes, reconnect, which should reset the computer and the light should go off. If it comes back on, there is some kind of problem still.
SOURCE: 1999 honda odyssey won't start, has power but won't start.
It's the neutral safety switch. Have your mechanic adjust it, or replace it if it's bad. For now try starting it in neutral instead of park or even try pushing the shifter up all the way (in park) while you turn the key.
71 views
Usually answered in minutes!
×