SOURCE: replace the alternator on a 97 isuzu rodeo
from Yahoo answers
The alternator is located on the passenger side of the motor at the bottom. There is a bracket attached to the motor and the alternator. You need not take the bracket off to remove the alternator. Two bolts hold the alternator to the bracket. One bolt is on the front top of the alternator and one bolt is located on the bottom front of the alternator. The bottom front bolt is attached to the tension adjustment for the alternator. Loosen the tension screw then remove the bolt going through the tension adjustment. After you loosen the top, front bolt, the alternator should be loose enough to move side to side. Remove the top, front bolt. Now you must disconnect the alternator from the power supply. Behind the alternator is a screw with a wire attached via nut. Remove this wire. Nextly there is a series of wires with a plug on the end. It is plugged into the side of the alternator. Uplug this item. You can also access both of these from the passenger side front tire well. Something to consider is that remanufactured alternators in Rodeo's as well as the Honda Passport (which has the same engine as the Rodeo) do not work and the problem(s) associated with a bad alternator,ie; not charging, no fan blower, battery light and brake light on, still exsist after replacing alternator with reman. Use a factory original alternator if possible. It will cost a little more than a reman but will most likely save you a lot of time and headache!
Hope this helps you out!!
L
SOURCE: 2000 isuzu rodeo removal and installation of serpentine belt
All u need to do is put a wrench on the tention pully and turn it clockwise... this will relive the tention take off the old belt ....put on new one. repeat relive pressure again ...slip it on pully... and relese tention..... done! :)
SOURCE: water pump replacement 96 isuzu rodeo
Remove belt, fan, fan shroud and fan bracket. Remove timing covers, timing belt and water pump. Replace timing belt and the hydraulic tensioner with new ones. I suggest you get a mechanic to do this as you can easly get it out of time. Not an easy job.
SOURCE: isuzu rodeo 2000, LS, anti-theft alarm needs to be reset
This has to do with the Auto's Computer system and should ONLY be done by a Factory Rep who knows what he/she are doing. not a home mechanic chore!!
SOURCE: I have a p0401 on my Isuzu Rodeo, but I have
Yes this is a very common problem on Isuzu's the EGR was most likely Ok. It's the passage that's clogged, good news is it costs nothing to fix, straighten out a clothes hanger, take the air tube right behind the throttle body and unbolt the throttle body. slide it out of the way and look inside engine with flashlight and you will seethe tube clogged with carbon. Now, use throttle body spray cleaner and spray into tube while clening it out with a hanger as well, it's usually the last 1/4" that's clogged. 85% of the time the tube is clogged causing a po 401. Only 15% the EGR valve is bad. have fun and happy motoring!!!!!!!
67 views
Usually answered in minutes!
×