SOURCE: how do I change my headlight bulb
go to your parts suppler and ask for a H4 globe pop your bonnet and remove the plug on the back of your head light then remove the rubber boot paying attention to which way it cam off then you will find a spring clip unclip it but be careful not to damage its anchor point. remove old globe an throw away take new globe out of box DO NOT TOTCH THE GLASS OF THE GLOB AS IT WILL CAUSE THE GLOBE TO BLOW STAAIGHT AWAY AFTER FITTING IT handle the globe by the metle bass and fit it, refit spring clip and rubber boot fit the plugf and check the operation of the light
bingo you are done have a nice day
SOURCE: Replacing bulb on lowbeam headlights--2006 Outlander
There may be a small wire clip holding the light in, you should be able to remove it with your fingers.
SOURCE: How to change the headlight bulb on a 2001 mitsubishi galant?
On either side of the headlight wiring assembly, in the engine compartment, you will find 2 small tabs. They are located to the sides and towards the bulb of the plastic assembly. Press these 2 tabs in while pulling the wire assembly out. Remove the rubber gasket and unhook the wire spring holding the bulb in place. The bulb come right out. The bulbs are halogen so do not handle the new bulb by the glass.
SOURCE: mitsubishi outlander cooling fans not operating
There is a Recall to replace your cooling fan module because of this concern.
Open your hood and look at the black box bolted to your radiator fan by the battery. If it does not have a green dot on it, you have not had the replacement fan module installed.
Contact your local dealer with your VIN handy to verify the recall has not been done and to schedule an appointment.
If the recall has been done, verify if you have power coming out of the module to the fans, as the fans do burn out eventually.... but rarely both at once.
SOURCE: how do you reset change oil light on mitsubishi outlander
Turn the key off.
Press the "Info" button on the left of the dash cluster until your maintenance miles/months screen is displayed.
Press and hold the "info" button until the maintenance screen begins flashing.
Release the "info" button and then push and hold it it for one second.
Your Maintenance intervals should reset to +6 months and +7500 miles since the last interval amount.
Note that if you have not reset it for more than one interval, you may need to do it more than once. If you have not done it for many intervals, you may need to have it reset with the scantool at a dealer, as I have run into a handful of vehicles that the oil change reminder locked up after 3-4 "intervals" were skipped/not reset.
785 views
Usually answered in minutes!
×