How to repair
SOURCE: 2000 Honda Accord Check Engine light on p0740
YOU HAVE A TORQUE CONVERTER PROBLEM. TORQUE CONVERTER CONTROL CIRCUIT MALFUNCTION CODES CAN COME FROM ELECTRICLE TO INTERNAL MALFUNCTION. IF YOU START EXPERIENCING A HARD SHIFT OR FREE SPIN TO HARD SHIFT DON'T BE SURPRISED. TRY CHANGING FLUID. THIS MAY HELP. HONDA WOULD HAVE REPLACED TRANS IF UNDER 105 k FOR FREE. IF YOU HAVE TO REPLACE TRANS. BUY ONE FROM HONDA, 3 YR WARRANTY AND AS CHEAP AS A REBUILT TRANS. HAVE A QUALIFIED PERSON INSTALL, YOU WILL SAVE ABOUT $500 DOING IT THIS WAY. GOOD LUCK
Code P0108 means your MAP sensor circuit is open. MAP means Manifold Absolute Pressure. You should be able to buy one at your local parts store - otherwise, the dealer.
SOURCE: 2001 HONDA ACCORD CODE P0740 TRANSMISSION
Horsecrap...go to an independent transmission dealer after you call the extended warranty folks and complain!
I can count the number of Honda transmissions that go bad before 300,000 miles on one hand.
Good Luck
SOURCE: 2002 Honda Accord V6 check engine light on- local
po505 idle air control if this is the code all hondas do it eventully, small problem easy fix u have 2 choices either remove the idle air control motor and clean the inside of it u will find it's black and the spring inside is stuck clean it with carb cleaner or gum cutter any parts store will have this it's a dirty job it will work for awhile but to replace it is recommended its not expensive for a new one which u can get at any autoparts store autozone,advanced,napa etc. there is only 2 bolts in most cases maybe 3 i doubt it though if u go online t google and type in th eyear make and model and engine size in ur case it's a 3.0 v6 and look for idle air control locations u'll find it to do this job a shop will charge u anywhere from 100.00 for diag to retrive the code plus the part and the labor so about 250.00-375.00 it will only take u honestly maybe 15 minutes to perform only tools needed are a 10 millimeter wrench there is only 1 connector to disconnect and ur done if u do this u will still have the check engine light because u have not cleared it from the computer to do this just disconnect the negative battery terminal (the black one or has a neg sign - don't disconnect the positive side +)for 5 minutes then reconnect and the computer will have reset no more light. good luck it really is that easy
SOURCE: My check engine light and TCS light came on. Code
P0401: Isufficient Flow Detected in EGR system.
-clean the EGR port with the carburetor cleaner.
-clean the EGR passage inside the EGR valve with the caburetor cleaner.
Reset the light, if the light still coming back, then replace the EGR valve.
231 views
Usually answered in minutes!
×