How do you get to the bolts of the back seatbelt to replace the rear passenger seatbelt on a Toyota 2007 Avensis 2.0 Sedan?
Seat base is not bolted.Grab under front of base with both hands near the ends and just snatch up quickly.Pull the seat base out from the car and the bolts for seat belts are visable.
SOURCE: 2002 Toyota Solara Convertible seat belts not retracting
The front seatblet retractor springs have weakened. Unfortunatly, there are no "user serviceable parts" on them. They would have to be replaced. How many miles is on it? If you have low mileage, the Toyota Customer Experience Center may provide you some assistance, as the belt replacements are quite expensive. I'd call the CEC and explain your dilemma. Here is the number: 1-800-331-4331
SOURCE: replace rear seat belt in 1993 Toyota Corolla
OK. On the front edge of the seat bottom cushion, pull up hard, both sides. This will dislodge the 2 clamps that holds the seat cushion to the floor. Pull the seat cushion out & set it aside. You will now see the female latches bolted to the area where the rear of the seat cushion meets the rear seat back bottom. Remove the bolts (14 mm I think).
SOURCE: rear seatbelt
fold rear down take outter seat off one twelve bolt at bottom remove clps and pck tray YOU GOT IT
SOURCE: Passenger side seatbelt loose
clean seat belt with suitable cleaner. most of the time it doesnt slide through top piviot due to dirt build up
SOURCE: Vibrating noise from seatbelt pillar area on 2006 Corrola
they had a problem with that and they put foam around the assembly and used rubber bands to hold it on to stop making that noise, they have a campain on this and was a repair from factory.
1,304 views
Usually answered in minutes!
×