2007 ford escape 2wd i put the harness on for the

Your local auto parts store should have a wiring harness that will clip in to your existing harness. Modern vehicles mostly have a harness coupler under the back of the vehicle you can unplug and plug in the trailer harness without having to cut anything, making the installation very quick and painless. The harness plug may have a plastic lock which you will need to release to separate the two sides of the harness. I recommend putting dielectric grease in both sides of the trailer harness to prevent corrosion from knocking out your trailer lights. The trailer harness kit will have instructions and a diagram to guide you.
Hope this helps and please rate my solution!!

these are all snap together now. you buy the harness as a unit. it should tell you where to unplug your existing lights. this is usually on the driverside rear close to the bumper. you just unplug your existing light , plug in the new adapter then plug in the new trailor wires to the adapter. you get these at any parts house like autozone, even wal mart sells them. it is so simple it takes about 10 minutes.

you should'nt have to,all you need to do is to run a wire from one brake light to the plug if your brake light is a two filament globe ie. tail/stop light you need to make sure that you connect to the brake light wire.....hope this helps....cheers

see if you can follow the harness from the back of trailer it should go a short then plug into main harness,these sometimes get corroded, but first chack fuse box under hood for trailer lighting there are seprate fuses for L and right turn and brake

theres a plug/wiring that plugs into wiring of truck in the rear,uhaul may sell it if not go to a trailer store or check website,tpye in 2002 escape trailer wiring plug. it costs about 27.00 and heres a picture of it and it takes about 5 minutes to in stall hope this helps.

I have the same vehicle. Go to Ford dealer and buy the trailer hitch which replaces the regular rear end. It took me about two hours to install and I have towed a heavy trailer several times now with no problem. Because this is a unitized body/frame vehicle, it would be unwise to try to weld a generic hitch on. The Ford hitch fits right on to existing bolt holes. You have to cut a small square notch in the center of the plastic rear bumper for the hitch to stick out.
[email protected]

u must install the fuses for the system in he underhood heavy duty fuse box, it will be marked trailer tow

I had the sam problem with my '02 escape when I installed the hitch. I changed the turn signal relay under the dashboard on the drivers side of the dash with one from an escape that had a tow package(one was blue and the other was yellow...). worked fine for me after that. Don't know if it changed later...

should be located near the hitch.