SOURCE: window off track driver side 1997 sebring
You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door
SOURCE: Rear passanger window fell off track
First you need to remove the door panel, which usually is just a few philip head screws or 10 mm socket sizedbut before you try pulling if your car has a tweeter/audio on a corner of the window make sure sure you remove that first very carefully you don't want to force since it is only held by its on clips... Then once you are ready to remove the door panel start by inserting a flat head screw driver in between the metal and the plastic pannel.
Then star opening it in a uniform manner only start opening from side till you open it since it has a bunch of plastic clips going all around the pannel to hold it on the metal.
once it is open you might need a rachet, a 10mm or 12mm socket and an extension for thet rachet.
Look for about 2-3 round holes enough to fit the socket in connect the power and psition the screwns of the control arm holding the glass and lossen the screws so tha glass can be pulled out its better and recommended to be done by two persons one holding the glass and one removing the screws.and then when the glass is pulled out all the way out is easier to re-aling it and as well one person pushes down and holds the glass the othe one makes sure from the insid panel area that the glass is going on its channel/u shaper rubber all the way....sets the screws back of once is well positioned start tightening the screws back on...and test it with the swich once is done, if stays in the track it means that you succeeded and your control arm is in good working condition and as boost up put some kind of lube on its track from up to down....And if it comes off the track againg you might need to replace the control arm which is that piece that holds the glass with the screws on it...
and to star putting the door pannel back on start by aligning it on the top , make sure that that ruber that keeps touching the glass gets in all the way and then just make sure that all the clips holding the pannel are all attached to the pannel and so just start pushing the pannel against the metal and it shoul clip once is well positioned.then just put the screws you took off the pannel and you should be don....don't forget to carfully clip back the and connect the tweeter window if has one....and voilah...you're done.
SOURCE: driver window off track,went to
remove door panel, If you are mechanically inclined you can figure out how to connect the regulator (operating assembly) back to the window by removing mounting bolts of assembly and pivoting. Something came loose or broke, window guides are worn (plastic parts), or assembly is way out of alignment for window to fall off track....
SOURCE: My front driver window fell off the track or the
you should have adjustments along the bottom of the tracks, what you need to do, is get the window inside those glides, and squeeze the slides into the edges of the glass window, that should keep it in line and on track here watch this, it might give you a better idea, this is pretty much the same as with Most door glass http://www.youtube.com/watch?v=Uu3SiUyWo-8
557 views
Usually answered in minutes!
your window regulator cable broke
×