Wheel has play in wheel bearing
SOURCE: adjusting the auto kickdown on a 1994 Isuzu Mu 3.1 Deisel
there should be a cable that runs off the throttle body
SOURCE: Isuzu Wizard 1998 Front Wheel Bearing Adjustment
Jack up the wheel ,take off the allen screws (no oil) then see a locking ring with 3 cross head screws which will be very tight. take them out turn the adjusting ring cockwise and spin the wheel till the play is gone then get the next set of holes in line so there is a tiny bit of load on the bearings and bolt it back up - job done .
SOURCE: The three screws on the locking washer need to be
I dont drill them too tiny ! about metric 4mm .
best way is to get a small metalworking chisel and tap the outer edge in an anticlockwise direction - they give up easy .
Testimonial: "Will start tapping! Thanks."
SOURCE: WHEEL BEARING NEEDS ADJUSTING ON A ISUZU 1998
You buy a new one if it is a wheel bearing hub.if not it is a ring bearing place nut finger tight with a little more tension using a wrench then place cotter pin back in.
SOURCE: How do i adjust the front wheel bearings on a
I have a 96 model and the front bearings are not adjustable.They have to be replaced. I am sure you have the same set-up on your 94 model.
100 views
Usually answered in minutes!
×