Code: p0336 What should I do when I get this code p0336 crankshaft position sensor A CKT range/perf is this bad I notice that the car won't accelerate some times when u step on the gas to go it takes a long time to get up speed. Please respond...

CPS on a modern vehicle is the main input to the engine management computer to determine spark advance. If the CPS is toast then the EMC is not getting a good input to adjust timing.

http://engine-codes.com/p0336_pontiac.html

P0336 Honda - Crankshaft Position Sensor 'A' Circuit Range/Performance

Possible causes
- Faulty crankshaft position sensor
- Crankshaft position sensor harness is open or shorted
- Crankshaft position sensor circuit poor electrical connection
- Signal plate may be damage
- Starter motor may be faulty
- Starting system circuit
- Dead or weak battery

which crank sensor do you replaced ? the P0336 means P0336 Crankshaft Position Sensor A Circuit Range/Performance.

________________
autel maxidas 708

P0336 Crankshaft Position Sensor A Circuit Range/Performance.

Potential causes of a P0336 code include:

• Bad crank sensor
• Broken reluctor ring (missing teeth, debris lodged in ring)
• Reluctor ring dislodged/stripped from it's stationary location
• Wiring harness chafing causing short
• Wiring open in CKP circuit, good-day ! CKP=crankshaft position sensor. The Crankshaft position sensor also known as the crank position sensor is an electronic device used in an engine to record the rate at which the crankshaft is spinning. This information is used by the Electronic Control Module(ECM) to control ignition and fuel injection. The sensor system consists of a rotating part, typically a disc, as well as a static part, the actual sensor. good-day !
  
  
  

P0336 Chevrolet Crankshaft Position Sensor Circuit Range Performance

P0336="crankshaft position sensor 'A' --range or performance problem."

P0336 means Crankshaft Position Sensor A Circuit Range/Performance. Try replacing the crank sensor next.

http://www.check-engine-light.com

po336 on 97 lumina 3.1 is---crankshaft position sensor A ckt range /perf.---this is a bad crankshaft sensor!!!

po121 means that there is a problem with the throttle position sensor ( tps). or in the wiring or connector, most likely its the tps that is bad. first remove connection from tps, heres how to test. use an ohms meter and hook a lead to top or bottom terminal of tps. use other probe on center terminal of tps. move throttle plate slowly, if the needle on meter does not move at a smooth pace, then tps is bad. good-luck!!