Had only P0446 code replaced VSV. Now get P0446 and P0441 codes
SOURCE: p0440,p0441,p0446
These codes are all for the Evaporative Emissions System.
P0440- Evaporative emissions system fault- just saying there's something wrong with the system.
P0441- Evaporative emissions system- Incorrect purge flow- saying that the system isn't purging the raw fuel vapors (hydrocarbons- HC) as well as it should.
P0446- Evaporative emissions system- Control valve circuit low- there is a valve, usually located on the charcoal canister at the rear of the vehicle, that opens to allow fresh air to enter the evaporative emissions system as the engine vacuum purges the fuel vapors from the charcoal canister and closes when purge is not needed to prevent leakage of those fuel vapors to the atmosphere (HC is a greenhouse gas and is regulated as such by the fed gov't).
Given that you have the incorrect purge flow code and the control valve code together, my bet is that the vent control valve has failed (causing the P0446) and is not opening to allow fresh air into the system to displace the air from within the system that is being pulled to the engine. Since you have no fresh air entering the system, the engine will pull a vacuum on the system instead of the vapors "flowing" into the engine (causing the P0441).
I hope that this is helpful to you!!!
ASE Master Technician with L1 and X1 Certifications; Nissan Scope Technician; Chrysler Level 3 Silver Technician- 12+ years experience.
SOURCE: 1998 toyota camry V6
P0420 indicates you have a catalyst efficiency issue; replacement of the Air-Fuel Sensor should take care of that;
The P0441, P0446 and (I assume P0440); you said 446 twice, indicates a faulty or loose fuel cap; it is not sealing properly.
Please feel free to respond to me if you have any further questions.
A FixYa rating from you regarding my assistance would be greatly appreciated.
SOURCE: 2003 toyota Matrix code p0441 and p0446...need help
p0441 - Evaporative emission control system Incorrect purge flow. can be caused by a lot of things and is usually related to a small leak in the emission control evap system, try replacing the gas cap and see if it helps, if not, the system needs to be tested for a leak with the scantool or a leak tester or both.
usually you will see p0440 p0441 and p0446 together but before anything replace your gas cap and besure to tighten it down when you gas up the vehicle, 90% of the time with those codes either a loose gas cap of bad gas cap gasket is the problem
Otherwise - Might be a canister leak, defective VSV valve or hoses, bad gascap seal.
Thanks for using FixYa - a FixYa rating is appreciated for answering your FREE question.
SOURCE: 2001 corolla chack engine light on.
P0440= Evap Control Sys Malfunction
P0441= Evap Control Sys Purge Flow Fault
P0446= Evap Control Sys Vent Ckt Malfunction
184 views
Usually answered in minutes!
×