Turn signal switch for 2014 equinox interchangeable with another year with fog lights?

2005 equinox
Don't waste your money on unnecessary sources and unwanted repairs.
Get this manual online under $10-15 and get complete guide on whether to repair or not, service it, and how to repair etc

Odd electrical problems (turn signal, dash backlight, hazard ...

www.bimmerfest.com > ... > 5 Series > E39 (1997 - 2003)
Aug 29, 2007 - 25 posts - ‎13 authors The turn signal in my 1998 528i has been acting up the last few days. ... switch flashes at times (but the signals or dash indicators don't light) ... Dash Indicators: Turn Signal and Sound, Fog Light ...
15 posts
Feb 3, 2014
Need help, radio and turn signal relay is not working
25 posts
Jan 18, 2010
Turning Signals and revers Light- Not working!!!
17 posts
Dec 15, 2009
Dash lights out, cruise not working, AC not wotking ...
25 posts
Aug 8, 2008
More results from www.bimmerfest.com

PCB Relays
This vehicle is equipped with the following printed circuit board PCB mounted relays.
• High beam
• Low beam
• DRL
• Fog lamp
• Park lamp
• Stop lamp
• Horn relay
They are directly soldered to the underhood fuseblock circuit board. A failure of one of these relays will require the whole under hood fuse block to be replaced.

Turn Signal/Hazard Lamps
The body control module (BCM) is responsible for controlling the turn signals and hazard lamps. When the turn signal switch is placed in either the left turn or right turn position, the BCM receives a signal from the turn signal switch. The BCM then sends an on-off voltage signal to either the left or right turn signals and their instrument panel cluster (IPC) indicator. When the hazard switch is pressed, the BCM receives a signal from the hazard switch. The BCM then will send an on-off voltage signal to all the turn signal lamps. All the turn signal lamps will flash including both IPC turn signal indicators.

Vehicles are just not the same as they use to be. Electronics !!!!!

Was it wrecked? I would think a 1 year old car should still be under warranty. Anyhow, sounds like possibly a bad connection at the battery terminals.

Hi Mike, You mentioned the turn signal switch can cause burning plastic smell from under the hood (12 years ago on a Chevy)

I drive a 2005 Acura MDX Touring 4D SUV. Two weeks ago, I noticed a light flickering behind the VTM-4 button. At a stop light, I turned on the left blinker and it wouldn't stop blinking.

An hour before, my SUV would not start. When I turned the steering wheel slightly right, the car finally started. I was performing deliveries, so I couldn't take a chance for the car not to start again. Therefore, I just kept the car running to finish my shift.

When the blinker would not shut off, I had to end my shift. Once I arrived home, I just parked the car: The left blinker continued to blink. I tried to start the car again and it just clinked along with the blinking left turn signal.

The next morning, I attempted to start the car again. After a few unsuccessful attempts, I turned the steering wheel slightly right and it started. However, the left blinker remained on.

I tried to start the car once again and only heard clicking. All of a sudden, I smelled a burning plastic smell and a small amount of smoke came from under the hood.

I was thinking about pulling the fuse to the turn signal. I've had past challenges with starting the car and the VTM-4 and engine light light on. OBD codes produced a Bay 2 Sensor 2 O2 sensor. In the past, my left fog light got knocked off and the connectors are exposed.

Would greatly appreciate your expert advice on what I can do to start this car up and to cancel out the left turn signal. Thank you for your time.

Try to wire them straight to 12v to rule out anything with the lights themselves. You've tested with a meter to the leads at the light with them switched on?

If it is a double filament bulb, try to rotate by 180 degrees in base, since there is a difference in power and touch of the bottom pins

With the switch in sidelight or dip

position, pull the switch to its first

position to turn on the front fog lights.

Pushing the switch in or turning it to OFF
or AUTO will turn off the front fog lights (this is for the front)

With the switch in any position except

OFF or AUTO, pull the switch to its

second position to turn on the rear fog

lights. This will also turn on the front fog

lights unless main beam is selected.

Pushing the switch in or turning it to OFF
or AUTO will turn off the rear fog lights (this is for the rear)

Exterior lighting

Exterior lighting switch

A. OFF.

B. Side (parking) lights.

C. Headlights.

D. Auto.

E. Front fog lights.
F. Rear fog lights.

It is the round knob nest to the steering colume

i have 2001 Audi is a liking gas problem