SOURCE: 2000 chevy 1500 truck stuck in 4-wheel drive
the shifter accuator or the wires going to it on the transfercase..gl
SOURCE: Replacing upper ball joint (2001 Silverado 1500)
try autozone for a diagram and assistance and you can also rent the tools needed for the job
SOURCE: how to remove lower ball joint 2001 chevy silverado 2500 hd 4x4
The reason is they are pressed in and you have to press them out with a tool and some have a C clip that has to be removed you can go to schucks or autozone to rent the tool to press out and it has to be pressed back in.
SOURCE: replace upper ball joint 2003 silverado 1500
The ball joints on both 2wd and 4wd upper are pressed in you need to remove snap ring and using a hammer pop out the old one out this is after you seperate the upper arm from the spindle. To install the new ball joint you should use a ball joint press that you can rent at most autoparts shops
SOURCE: how do i change my upper and lower ball joints
Jack up the car remove wheel remove brake caliper and remove rotor rent a ball joint press remover and installer tool (at schucks you get money back when you bring it back) if it's 4 wheel drive you will have to remove the axle shaft next pull the snap ring off on the top side and put tool on the lower tie rod end and press out, next do the top press out top joint next sand ball joint sockets so it is clean lube with WD-40 next press in top ball joint and then lower ball joint. In this order otherwise you will have to un install the top ball joint by removing the pin then nut.
42 views
Usually answered in minutes!
×