Replacing rear shocks on toyota camry

This model usually wears out the rubber bushes in the rear sway bar retainers to the body, causing an annoying knock. Have a look there. See p95

http://www.turboninjas.com/camry/sa.pdf

New shocks never go astray in a car that age, they give you, um, a tight rear end.
.

Hello. Welcome to FixYa.
Front struts: 1 hour per side times your areas labour rate
Rear struts: 1 1/2 hours per side times your areas labour rate.
Add a 4 wheel alignment price after the struts are changed
Thanks for choosing FixYa.

Do you take the car back to the shop that put them on? They should be guaranteed, let them replace them and they should know what the problem is.

http://www.chiltonsondemand.com/search/results.html?keywords=801983118+or+801989558+or+1563920301&dummy=dummy
http://www.haynes.com/products/productID/293
http://www.haynes.com/products/productID/37
Have no idea the best one.They do exsist.Have you tried your local library? Or you can look on ebay.

if you bounce the car by putting your weight on the rear bumper with your knee you can test the rear shocks. If the car bounces more than once on the way up you need shocks. I generally replace shocks on new cars with factory installed shocks anywhere from 40,000 - 50,000 miles. There are bolts at the top and bottom of the shocks that will have to be removed. You can do this a little easier by removing the rear wheels and placing the car on Jack Stands.

struts

When the strut was removed, the wire from the harness to the wheel speed sensor was not removed, and it was broken. An easy omission, for those without knowledge of the existance of wire.

It costs about $192.00 to replace the sensor..

if its centre belt remove rear seat to undo bolt out side one remove cover on upper belt to expose bolt

The rear wheel bearing on a toyota camry is replaced by replacing the wheel bearing and hub as a unit. this is a design change as compare to older models with two piece wheel bearings. Scotch drive wheels. Remove rear wheel. Remove rear brake drum. (note: if emergency brakes are applied you will not be able to remove brake drum) Remove dust cap and hub retaining nut. Hub should slide off as unit. Replace hub with new unit. Installation is reverse of removal.

I use the same model of car with you. It is a non-serviceable part that you use in the replacement of your struts.

Good luck.

Rate this solution.