SOURCE: 1987 Ford Ranger 2.0 Liter Vacuum Line Diagram
can you see the diagram under the hood? if not try searching a junkyard for either the diagram or a complete motor
SOURCE: Replace heater core in 1988 Ford Ranger
allow the system to cool down
take radiator cap loose to release pressure
once pressure is released tighten cap
loosen clamps on the heater hoses in the engine compartment on the pass. side of firewall.
plug or cap off the heater core tubes to prevent spillage when you pull it into the truck
place a trash bag on floorboard in case spillage occurs
remove the five screws holding the heatre core access cover, three on top and two on bottom
carefully pull heater core back and down and remove it from the dash
install is reverse
Hope this helps
SOURCE: I need a fuse panel diagram for a 1988 ford ranger
This is listed under a L4...you didn't post your motor size so please pick the one that is applicable to your motor size:
Hope this helps.....if it is too small to see, email me at [email protected] and I will email you a larger version.
SOURCE: I need a diagram for where the vacuum hoses go to
Check out the autozone.com website and register the truck there. It doesn't cost anything and will give you access to an online repair manual for the truck. The vacuum diagrams should be available there. Hope this helped and best wishes.
SOURCE: i need vaccuum diagrams for a 1988 ford ranger V6
Fig. 19: Vacuum hose routing-1989 2.3L EFI engines;
calibration 9-50K-R00
Fig. 20: Vacuum hose routing-1989 2.9L EFI engines;
calibration 9-65F-R00
Hope this help (remember rated this).
220 views
Usually answered in minutes!
×