Has no fire or fuel
The spark problem is first because the computer uses the same signals to control injection Ford used two types of ignition systems #1 closed bowl this has the control module mounted on a heat sink next to the drivers hood hinge and 6 wires coming out of distributor or thick film where the module is mounted on distributor on both systems need to test the pick up coil with a logic probe for cycling voltage ok replace module if not ok replace pick-up coil.
SOURCE: rear axle seal replacement 1994 ford bronco
It is fairly easy to do. remove rear wheels and brake drums, remove the differential cover, rotate the diff to access the diff pin bolt and remove, remove pin, push axles inward and remove c clips, slide out axles and replace seals. reverse procedure
SOURCE: 87 ford bronco fuel gauge problems
The problem is most likly the sending unit in the fuel tank but check the float. drain tank, there are two bolt in the straps on the fuel tank lossen enuf to lower tank to get to top to unplug wires and fuel lines once tank is on the ground thee is a ring on the top of tank holding the pump and sending unit in tap ring around with a screw driver to lossen once you have that off just pull unit out of tank and follow directions that come with sending unit. reverse removal procedure. good luck.
SOURCE: firing order for 1989 full size ford bronco 302
13726548 #1 cyl is front pass side and count to back 1234 are on pass side.5678 are on driver side.# 5 being front
SOURCE: 1994 Ford Bronco SRS light flashes 32 code.
Probably code 32 which has to do with the egr system. Check you vacuum lines.
SOURCE: 1994 ford ranger. won't start, good spark,fires,
could be many things , but fuel and fire are a good sign. check the ESC, and that you have a full 12vdc in the vehicle, then check that all cyl have fire, poss bad coil pack
286 views
Usually answered in minutes!
×