SOURCE: 2000 Isuzu Rodeo hood release
My hood release inside the car just broke how do I get it to maually release?
SOURCE: 2000 isuzu rodeo brake problems
your master cylinder is gone. when stopped apply pedal and hold let up slightly then reapply if pedal sinks to floor master is bad.
SOURCE: engine knocks 3.2 isuzu rodeo 2000 ? help
You don't say how many miles or give a service history, but, that said I would check the timing belt and tensioner. When tensioner goes bad is often is reported as a loud knock or tick. Usually most evident at low RPMs. Another low cost try is to use a can of seafoam in the oil now, run it a few miles, then change it for a high detergent, low viscousity oil and drive it a while to see if the lifters clean up. engine tick is very common, generally due to lifters oil passages getting sludged up a little for 2nd gen 3.2l's
SOURCE: 2000 isuzu Rodeo wont start
Could be your neutral safety switch, or it's not all the way in park. Broken or loose wires in the starting circuit. Inspect all wires and connectors at the battery, starter solenoid, and ignition switch. Or your starter pinion is jammed in the ring gear. Remove starter and inspect. Last but not least, your engine is seized. You don't want that one. Good luck.
SOURCE: 2000 isuzu rodeo trans range and leak problem at $1000?
I have a v6 2000 rodeo and the transmission contiunes to have a slip in it what should I do!! I have been having this problem since I purchased the car brand new in Oct 2000!! What should I do
34 views
Usually answered in minutes!
×