Where is shift interlock solenoid located on 1996 mercury villager?

SOURCE: where is a knock sensor for 1998 Mercury Villager located?

Here is a image of it's location, I hope it helps.

Marvin

• 85242 Answers
• Posted on Mar 08, 2009

SOURCE: location of the engine diagnostic connector 1995 village mercury

The diagnostic connector is located on the engine near the starter. However, there are four connectors in that location and without pictures it would be difficult to determine which is the proper one

SOURCE: 95 Mercury Villager will not start

check/replace the starter relay switch in the relay box under the hood. The relay box is located on the front right of the engine compartment. easy fix, inexpensive part if that is the problem.

Marvin

• 85242 Answers
• Posted on Jun 22, 2009

SOURCE: 1996 Mercury villager 96,000 miles- dies out

Here is the common cause of surges, stalls at stops, slow idle speed, erratic idle speed, rough idle and engine hesitation (and other problems), it is in most cases the idle speed control air-bypass valve and or throttle valve and upper intake, these area's get full of gunk and combustion residue over the miles and cause idle issues (stalls, low idle) like yours, Get a can of intake cleaner from any local parts store, not carb spray, intake cleaner, it is made by a company called CRC, remove the air intake hose to the engine, hold the idle high so the engine won't stall, then spray the can of cleaner into the intake while keeping the engine running, use at least 1/2 the can, shut down the engine and disconnect the battery for 5 minutes, then restart and complete a number of mixed driving cycles, town, freeway, stop and go etc., after a few days the problem will go away as the system will relearn to the clean intake.

SOURCE: Rear brake lights remain on.

just simply unplug connector from brake switch located at base of brake pedal, if lights go out switch is bad, if lights do not go out you have a short to power on brake lamp circut before turn signal switch