Cars & Trucks Logo

Related Topics:

A
Anonymous Posted on May 01, 2014

Suzuki jimny 1.3 carburator engine stop when ideling

Car run well when travelling at high speed but engine stop when car slows down or stop

1 Answer

Bill Boyd

Level 3:

An expert who has achieved level 3 by getting 1000 points

Top Expert:

An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

  • Suzuki Master 53,816 Answers
  • Posted on Oct 24, 2015
Bill Boyd
Suzuki Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Top Expert:

An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

Joined: Jan 04, 2013
Answers
53816
Questions
7
Helped
11940885
Points
172802

Check for a vacuum leak
check idle adjustment
check for idle circuit solenoid is operational

5 Related Answers

Rajeev rai

  • 14 Answers
  • Posted on Mar 09, 2009

SOURCE: CAR suzuki swift 1.3 diesel 2008 (BRAKES)

please go for a brake bleeding..might be some air is trapped inside your brake system..

Ad

Anonymous

  • 129 Answers
  • Posted on Jul 15, 2009

SOURCE: maruti zen engine stops working when running on slow speed.

hi
the problem may be due to the clutch plate and when your in low speed , increase the rpm ,what i mean is to raise the engine so that the engine will not stop

co7196

Ned C Cook

  • 3433 Answers
  • Posted on Jul 25, 2009

SOURCE: 1. My Suzuki Vitara 1995 gives me black

It's running too rich.and the coolant temp or intake air temp can aaffect that.

Anonymous

  • 102 Answers
  • Posted on Sep 21, 2009

SOURCE: valve timing check

Chain drive. Unless the engine's been apart, why would the cam/valve timing change?
Valve clearances are another matter, and unless you want to remove the camshafts, get a mechanic who has the proper Suzuki tool to do them for you. You can measure the clearances, but the shims are between the cam lobe and the valve bucket, and the special tool holds the bucket down whilst changing to a thicker or thinner shim.

baugh55grfmj

Mitchell Baughman

  • 225 Answers
  • Posted on Jan 12, 2010

SOURCE: I have a Suzuki Jimny the engine turns over but

It is in the tank, on top of the tank. It must be dropped to access the fuel pump. If You turn the key forward till your auxiliaries come on, you should here the fuel pump if you listen with your ear to the gas pump spout. It will make a dull whiny noise if it is working.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
2answers

I have a Suzuki Jimny 2005. It overheated and smoke poured from underneath the bonnet. I am not an engineer. Any ideas?

Yes you have likely burned up the engine and that is what all the smoke is about. Also you may have a massive coolant leak, maybe a radiator hose or other cooling system component.
1helpful
1answer

My Suzuki jimny 2007 looses power and takes a long time to switch gears and also at high speeds over 80 steering wheel shakes help email me also [email protected]

get it serviced?
2 problems ,
first slow down, in older cars. Huh? tempting fate?
get the wheel bearings check first.
car must be 100% road worthy to go fast. (to learn ask)

id not drive it. not me.
not until many checks for safety done.
do you need list.?
go to any brake , tire or suspension shop and ask them to diagnose this. what if a wheel bearings is seizing slowing car.
is the steering pulling, if yes, stop driving it. and for sure 80!

or better any ASE Auto repair shop (pros) they will check it all.
and then you will be safe, and us behind you too.
0helpful
1answer

Where is the baromic sensor fitted

the MAP, sensor, right? where is it?
why do you ask, curious? , someone stole it?
or got DTC errors that say, MAP dead. ?
why not just post the symtoms or buy the FSM and read it like above post. but above post is for USA cars, and there are no Jimny here, at all. and none on the above site for the same reasons
this is a USA forum not UK or European, it only covers USA cars.
why 2, why not tell country , engine controls run and work different on all countries (due to smog laws, etc)

the ignitor in most suzuki's moved to 2 places back in 1990s (late)
to the COP coil (DOHC engine) or to the ECU. itself.
my 96 still has a fire wall 4 port Ignitor J18 engine. but was moved in 97.

where is your jimny, (no address,) just a country,.
suzuki has like 56 engines and 95 markets. so.....
in your case we are 1 engine, and 95 markets.

why3, why ask for easter egg hunts? nobody here can answer.
post your VIN, then we can, (put xxxx at end for privacy)
1helpful
1answer

My Suzuki jimny stoped whiledriving

many suzuki have 2 baros, mine has 3.

one for altitude, inside ecu,

one for map TBI engine, (map sensor main 108 fails )

one for EGR map, to test EGR only. (my G16b has it)

we dont have 1.3 Jimny's here so can look it up for you.

but the FSM for your car (book) has this.

the P0108

is the main engine map sensor. (using usa fed rules for OBD2)

yours is EOBD rules. (im clueless with those)

that is used to calculate all air flow through the engine

it's output is stuck high,,

it's unplugged is my guess.

our map does 3.9V with the vacuum hose pulled. or just key on.



over 3.9v is illegal voltage and is bad map or unplugged.

when it goes to near 0v.volts at full vacuum 29"



this page may match your map for all voltages and states.



http://www.fixkick.com/sensors/my-map.html



that is my best idea here , lacking non USA books,
0helpful
2answers

Suzuki K6a engine. Turns over but won't start

we dont have this engine in USA< (this forum is USA forum.....)
what year, what car? ?? what country?
the k6a fits many cars, and many years and can be carb or EFI fueled.

the K6a line up, do tell what you are driving....please.
now to answer in GENERIC Mr. Otto Cycle mode. (gas engines)
no spark, check spark.
never tuned up, ever.
low compression, find timing chain slipped or worse.
twin cam 3 cylinder.
with chain drive. if chain is/was quiet, the cam timing should be good. as is compression over 150psi.
if compression is good, and spark good, x3
then it will run on test fuel, does it?
of not clogged melted CAT?

1helpful
2answers

I have a 56 plate jimny the fourwheel drive light is on on the dash is it stuck in fourwheel drive ?

Did you reverse more than 10 metres? Sounds like the hubs are locked into 4wd.this will work if you have auto hubs.but sometimes you have to turn the hub manually if they don't disengage.if you have gone some time or distance in 4wd
2helpful
2answers

How do I set the idel on a 2001 Jeep Cherokee?

the idle is controlled by the computer. you have to have the ecm reflashe dby a professional
10helpful
2answers

How to adjust air fuel mixture on a 87 suzuki samuria

On any carburator,one screw is for the idle speed, the other the air/fuel mix.Start the engine and let it get plenty warmed up. Adjust the idle screw to make the engine run slow. Turn the air/fuel screw in until the engine starts to die then out till it starts running loady.You want the screw between these two locations. Adjust it till the engine runs the fastest. Now adjust the idle speed screw to about 1000 RPM.
I hope this helps you.
Not finding what you are looking for?

302 views

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...