2013 Chevrolet Cruze Logo

Related Topics:

A
Anonymous Posted on May 05, 2014

My chevy cruze 2013 engine fan does not operate even with the ac switched on

My chevy 2013 cruze has the ac lines disconnected from the condensor. with this said will the engine fan go on in this state? The engine starts and temp rises but i am checking to see if the fan will come on and it does not. Do i have to have the ac lines connected for this fan to operate?

5 Related Answers

emissionwiz

Marvin

  • 85242 Answers
  • Posted on Oct 20, 2008

SOURCE: 2000 chevy venture cooling fans not working issue

The PCM may be defective.

Ad

Anonymous

  • 94 Answers
  • Posted on Jan 28, 2009

SOURCE: cooling fans on 2001 chevy malibu will not come on unless ac on

the relays control circuit is grounded by ECM (computer) . to check this make sure the is hot enough for the fans to be commanded on by computer and check to see if you have voltage at relay and it has ground from computer . you may need ECM.
good luck

Anonymous

  • 79 Answers
  • Posted on Mar 22, 2009

SOURCE: 2005 chevy equinox temp gauge showing hot fan

check the coolant temp sensor

Anonymous

  • 11 Answers
  • Posted on Jun 12, 2009

SOURCE: 2000 chevy silverado normal operating temp 210 ,

With the truck running at operating temperature, squeeze your upper radiator hose. You may have to check it a couple times allowing time for your thermostat to open. Are you able to compress the hose a little when you squeeze it or does it remain stiff/solid? Your thermostat may be stuck open or even stuck closed.

dogwoodlx

  • 3 Answers
  • Posted on Oct 15, 2010

SOURCE: I HAVE A 2007 CHEVY COBALT THE CHECK ENGINE LIGHT

I had this problem with a 2007 Chevy Cobalt. I changed the coolant sensor and even though the check engine light went out I still had a reading of "---" on the coolant gauge. The problem is most likely one of three things: a low coolant level, a bad coolant sensor, or the thermostat needs to be replaced. The only other possible thing it could be is a bad BCM (Body Control Module) which in that case you would most likely be having other weird problems.

The Thermostat and the sensor are both very easy to get to and replace. Take off the engine cover by removing the oil cap and they are both to the rear of the engine on the driver's side. They are right next to each other.

Hope this helps!

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer
1helpful
4answers

Why is code 91 on screen?

About 1,080,000 results (0.79 seconds) Search Results

    Chevy Cruze error code 91 - Fixya

    www.fixya.com/cars/t18378173-chevy_cruze_error_code_91
    Jun 2, 2013 - Chevy Cruze error code 91 What is Error code 91? It appeared ... Ya i know that what is error code 91 it is that ur car key is not there & if shows error code35 then ur car remote key cell losing his power exchange with that cell & ur car is ok. Posted on ... SOURCE: chevrolet cruze 2.0 LT 163cv error. If im not ...

    Warning: Cruze Start/Stop button & Immobiliser Design Flaw ...

    gearheads.in > Forum > Indian Automotive Scene > Chevrolet > Cruze

    Apr 16, 2013 - 10 posts - ‎7 authors
    4kms later I realised that I had the Cruze key with me in my pocket ... If the key is outside the car and you try to start it, it throws a Code 91 Error ...

    Cruze error code ' Chevy Cruze Blog : Chevrolet Cruze Blog

    www.cruzeblog.com/cruze-error-code/

    Translate this page Mar 7, 2014 - Cruze Error Code Vehicle message 1 C
0helpful
1answer

Chevy cruze problems

Most likely the shift neutral park switch is not engaging the ign lock solenoid
0helpful
1answer

How to change a cooling fan relay on 2012 chevrolet cruze

what will happens if coolant relay 12 missing Chevy Cruze LS 2012 ??? Please answer
0helpful
1answer

Outside temperature on Chevy Cruze

IF IT'S A 2013 TAKE IN IT'S UNDER WARRANTY.
0helpful
1answer

Need to know where is the location of switch to turn on the radiator fan

1995 Isuzu Rodeo is equipped with a belt driven fan with a viscous fan clutch for engine cooling. The electric fan is for A/C condensor cooling only. The condensor fan is switched on and off by the A/C fan relay, which is operated by the triple pressure switch located in the A/C line on the left side of the engine compartment.


12_4_2011_8_54_27_pm.gif
DO NOT
attempt to replace the triple pressure switch without first using the proper equipment to evacuate and recover the freon in the A/C system. The A/C system is under high pressure and attempts to replace parts without discharging the system can result in serious injury.
0helpful
1answer

Location of ac high pressure cutout switch on a 97 Plymouth voyager. Could it be a different problem? Had to replaced the PCM and a couple sensors because of a short in the wiring cluster. Now the ac...

HIGH PRESSURE CUTOFF SWITCH LOCATED ON AC COMPRESSOR DISCHARGE LINE LEADING TO THE CONDENSOR.THE HIGH PRESSURE CUTOFF SWITCH WILL CUT OFF THE AC COMPRESSOR IF SYSTEM PRESSURE RISES TO HIGH CAUSED BY RESTRICTION IN THE REFRIGERANT CIRCUIT OR OVERHEATED CONDENSOR.MAKE SURE COOLING FAN IS RUNNING WHEN THE AC SWITCH IS ON.THE COOLING FAN KEEP CONDENSOR COOL, IF COOLING FAN DONT RUN.YOUR AC WILL STOP BLOWING COLD AIR.HAVE THE REFRIGERANT SYSTEM CHECK OUT.MAKE SURE YOUR LOW SIDE PRESSURE IS 10 - 37 PSI. THE HIGH SIDE PRESSURE SHOULD BE 112 - 210 PSI. CHECK THE AC COMPRESSOR CLUTCH FUSE AND RELAY.
0helpful
1answer

My 91 Chevy pickup overheats when the AC is running. It normally runs 150 degree, but when the AC runs, it climbs to 220-240. All fluids and belts are OK. Thermostat is OK

is there a grill insert if so remove
is condensor clean (front a/c rad) clean with garden hose pressure
are fins of condensor folded over (they can be comb back to shape)
is engine cooling fan working when engine hot rev engine and look at fan
to see if fan responds to engine rpm properly
if fans electric check to see if power is there when a/c is switch on
should go on immidiatley with a/c switch on
0helpful
1answer

LOOKING FOR R&R STEPS FOR AUTO AC CONDENSOR.

i guess you are asking how to install it
here is how it works
first of all dont buy cheap things.im glad you bought this
here are the steps

Disconnect positive battery terminal.

Drain engine coolant.

Remove engine mounts (2) from van frame and flip them over backwards.

Remove the hood latch (leave cable connected)

Remove the two bars that connects the frame to the inside fender.

Remove the engine coolant overflow tank

remove air filter cover and filter and accordian hose

Remove upper and lower rad hoses

remove the two brackets that holds the rad

remove the two bolts that holds the fan assembly to the rad (one each end)

unplug fan plug

unhook lines from bracket at bottom of fan assembly.

remove fan assembly.

remove bolts from ac lines to condenser.

remove bracket that holds ac lines to rad (I think it's the rad)
lift rad upwards and away from frame enough to lift condenser out.

hope it helps-

Not finding what you are looking for?

852 views

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...