How to remove driver side door panel 2003 ford expedition
First disconnect negative battery terminal.Underneath of armrest there is two screws, remove them, using small screw driver pry out armrest switch control plate and remove screw behind it, pry of the side mirror cover using wide putty knife. carefully start prying from the bottom of the door around going toward the top then lift the door panel over door lock knob. Carefully look under and disconnect all electrical connectors and remove the panel. Installation is in reverse order of removal!
SOURCE: 2003 ford expedition "door ajar" & interior lights staying on
the wire on the door latch make sure they are plugged in or unplug it and the light should go out if it does not then it's not that door
SOURCE: how to replace the light bulb on exterior mirror 2003 ford expedition
The one with the turnsignal intergrated into it?
If so.....
Push the Mirror FORWARD, up close to the pivot poit there is a small torx head screw - unscrew that.
At the tapered end carefully pull/pry down. That end has a small metal spring clip that holds it up, be careful with it, if it snaps, you can NOT by a new one...
SOURCE: 2003 ford thunderbird how do you remove inner door panel?
You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door
SOURCE: disarm and remove ford expedition air bags
Remove the negative cable from your car battery before replacing car air bags
Deactivate the air bag by removing the air bag fuses. Look in your car owners manual to locate the fuses
Unscrew steering column paneling and remove the airbag bolts on the back side of the steering wheel. Pull out the airbag until you see the back side and unplug the wires
SOURCE: how to remove front driver side door panel (2000 ford expedition)
There is a triangular piece, at top corner, covering a screw behind the mirror. Remove that screw. Remove the piece that covers the handle and remove the screw holding the handle to the door. Look through, where door handle was and remove another screw just above where the handle was. This screw is holding the panel to the actual door. Pop the cover off for the automatic door locks and disconnect them. Lift the panel in an upward direction.
687 views
Usually answered in minutes!
×