Cars & Trucks Logo

Related Topics:

A
Anonymous Posted on May 07, 2014

Where are the freeze plugs located on a Alero 3400

3 Related Answers

Anonymous

  • 840 Answers
  • Posted on Jul 26, 2009

SOURCE: 1999 Olds Alero 3400 motor -- location of Crankshaft sensor

Welcome to fixya. If you need anything else go to www.collisionrepairadvice.com here is the location.
On the lower rear of the engine (LA1) for the 7x
and for the 24x

On the lower rear of the engine (LA1

Testimonial: "Got it Thank You!!! Actually my problem was a bad fuel pump in the gas tank."

Ad

Jonah Oneal

  • 14092 Answers
  • Posted on Aug 18, 2009

SOURCE: Hose reassembly of a 3400 sfi engine in a 1999 olds alero.

YOU GOING TO HAVE TO GO TO DEALERSHIP.THEY PROBABLY CAN PULL UP YOUR HOSE DIAGRAM ON COMPUTER.BUT THE HAYNES.REPAIR MANUAL DONT SHOW ENOUGH PICTURES.NOW A OLDS ALERO REPAIR MANUAL FROM GM WILL SHOW YOU EVERY THING.BUT THEY ARE EXPENSIVE.OR YOU CAN GO TO AUTO ZONE AND BUY THE CD- ROM ALL DATA DIY.COM.IT WILL PROBABLY HELP YOU FIND HOSE DIAGRAM YOU NEED.

Jonah Oneal

  • 14092 Answers
  • Posted on Jul 12, 2011

SOURCE: I cannot locate the wiring

ENGINE COOLANT TEMPERATURE SENSOR WIRES COLOR YELLOW AND BLACK.WIRE HARNESS NEAR THE THERMOSTAT HOUSING.

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Where is the freeze plug located on a 03 alero

FILL THE RADIATOR FULL OF WATER AND IT SHOULD SHOW YOU WHERE ITS LEAKING FROM THAT WHERE THE FREEZE PLUG IS ,I HOPE ITS NOT THE ENGINE BLOCK THATS CRACKED : )
0helpful
1answer

How do you connect a new wire harness to correct places on a 3400 sfi?

what color are the wires and are they a flat plug, round plug etc: ?
0helpful
2answers

Need location of crank shaft sensor on a 1999 alero

zjlimited_1899.jpg

Fig. Showing the CKP Sensor Location on 2.4L Engines

0helpful
1answer

Have a 2004 olds alero, 3400 sfi v-6, need to replace the o2 sensor, where is it located and is there a manual for this vehicle..? Are there any illustrations/pictures available for this procedure?

Its located in the exhuast pipe one before the cat and one after each catalytic converter.Yes your local auto parts store should have a repair manual.
0helpful
1answer

How do you route the serpentine belt for a 1999 3400 v6 oldsmobile alero?

DRIVE BELT ROUTING DIAGRAM LOCATED ON THE ENGINE NEAR WATER PUMP PULLEY.IF YOU DONT HAVE ONE AUTO ZONE AUTO PARTS STORE WILL PRINT YOU ONE.
0helpful
1answer

I cannot locate the wiring harness that the engine coolant temperature sensor comes out of in a 1999 oldsmobile alero 3400.

ENGINE COOLANT TEMPERATURE SENSOR WIRES COLOR YELLOW AND BLACK.WIRE HARNESS NEAR THE THERMOSTAT HOUSING.
2helpful
1answer

How much will it cost to have my water pump replaced in my 2000 Alero. I am getting a quote of over $1,000.00 dollars because of the position the water pump is placed.

Your 2000 Olds Alero should have the 3400 V-6 engine...the water pump sells for about $45. The change out does not require the removal of any major components...(ie engine mounts etc.) You can loosen the serpentine belt to gain full access to the water pump bolts...Yes you will lose some anti-freeze and need to refill after replacing the pump...antifreeze $8.50 per gallon...recommend you use antifreeze "Good for All Models" as it has proven to be the best for longevity...Hope this helps...Your estimate is way to high...A shop will mark up the part slightly, and charge for labor...This job should be completed in less than 1 labor hour...$55. to $75. per hour depending on your location...PLEASE shop around if you cannot do this one by yourself:)
5helpful
1answer

1999 Olds Alero 3400 motor -- location of Crankshaft sensor

Welcome to fixya. If you need anything else go to www.collisionrepairadvice.com here is the location.
On the lower rear of the engine (LA1) for the 7x
and for the 24x

On the lower rear of the engine (LA1
1helpful
1answer

Hose reassembly of a 3400 sfi engine in a 1999 olds alero.

YOU GOING TO HAVE TO GO TO DEALERSHIP.THEY PROBABLY CAN PULL UP YOUR HOSE DIAGRAM ON COMPUTER.BUT THE HAYNES.REPAIR MANUAL DONT SHOW ENOUGH PICTURES.NOW A OLDS ALERO REPAIR MANUAL FROM GM WILL SHOW YOU EVERY THING.BUT THEY ARE EXPENSIVE.OR YOU CAN GO TO AUTO ZONE AND BUY THE CD- ROM ALL DATA DIY.COM.IT WILL PROBABLY HELP YOU FIND HOSE DIAGRAM YOU NEED.
Not finding what you are looking for?

301 views

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...