Where is the bleeder valve on an 01 sebring - 2001 Chrysler Sebring

Two things will cause this, either it is out of time, or an intake valve is not sealing and allowing the combustion back into the intake.

did you remove the fault code disconnect the battery and that will take out the code

which one ? brakes? coolant? coolant is on top of the motor next to the radiator hose on the thermostat housing, be carful soak it with penetrating oil for one day so you don't break it. (do not drive while soaking it)

My daughter's 01 Sebring key doesn't have a chip, but the short battery cable was almost completely corroded through, acting like a dead battery. Check the cables for bad connections, too. I think both the pos and neg sides are each made of two short cables.

It is inside the transmission attached to the transmission valve body. You must remove the bottom pan of the ****** to access the solenoid pack

open bleeder see if it releases. if it does , replace brake hose

Coolant air bleeder???

Ensure brake lines are not cracked or loose bleeder valves.

Look at spending around 200-400 dollars to replace all the lines, and possibly calipers or wheel cylinders if the bleeder screws are rusted out also.

depending on what motor you have you may have to lift the intake manifold to remove the tube.the recommende procedure is to replace the intire housing.