Removing blower motor
SOURCE: How do I remove the
ffirst remove all screws that are holding it on approx 10, most are hidden by small round circles of plastic the same colour as the panel next you to be firm and pop it off from the door carefully there is about 10 of these clips which "pop" off then carefully lift upwards slighty unplug your electric window switch by pushing the tab on the plug itll come off. that's your door panel off. be carefull not to bump and of the metal wires you see running inside the door as these are to do with you door lock. to fix window gently pull down plastic moisture sheet on door first try another switch or give your switch a good clean, you can disasssemble it with a small screwdriver carefully, if still no difference replace your electric window motor which is bolted to the door in 3 places with 10mm bolts and is bolted to the window, unsure of what it is follow the wiring from the electric switch you unplugged will lead you to the electric motor, have fun
SOURCE: Heater Blower Motor
Remove the glovebox door, and the under dash cover/trim panel.
Look behind where the glove box was, you will see the heater box
At the bottom of this box, there is a round plate with a wiring connector and 3 screws holding this plate to the heater box.
This plate is the bottom of the heater fan assembly; remove the connector, and the 3 screws. The fan motor will drop staright down. Real easy to do.
SOURCE: heater blower noisy
there should not be no more then three screws and unplug and the blower is out and you say its noisy check for leaves and to make sure the blower is not hitting anything before you go to buy another one.
SOURCE: How do I remove brake drum on 2005 toyota corolla
Under normal circumstances, the drum should slide right off once the wheel is removed.
If you have built up rust holding it on, there are two threaded holes near the center of the drum to aid in removal.
Insert two 12mm bolts into the holes and, while adding plenty of lubricant, turn the bolts in even amounts until they push the drum off.
Be sure to keep them lubed, as they will strip out easily if not.
If you have aftermarket drums without the holes or the screwholes are stripped out, smacking the face of the drum with a dead blow hammer will help free it up, but takes much longer for success.
SOURCE: replacing a Ac Heater Blower Motor in a 2005
if youre sure that its the blower motor.......then HANG ON......cuz HERE WE GO!!!! k....open the passenger front door....get on your knees.....and look BELOOOWW the glovebox...there should be a black plastic cover...more than likely...that ya have to remove....after that....you can see your blower motor...should have three screws...maybe one more....and it will be released from the evap box....you then have an electrical pigtail connector you have to release and VIOLA!!!!!! there's your blower motor in your hands......install is opposite of reverse.....yeah I know that your knees hurt right now.....but...HOPE I HELPED!!!!!
386 views
Usually answered in minutes!
×