Head torque I NEE VAVLE CALIBRATION GATE

Question edited for clarity. Please always include YEAR make model as the first three words in every question.

In the link. Also check the images tab.

https://www.google.com/search?q=ford+mondeo+mk2+zetec+1.6+cylinder+head+torque

..

you nee a sender designed for that tank and your vehicle [theirs no calibration for senders ]

you can get guide from many sites.. i know few
error codes/ fault codes, wiring diagrams, schematic diagrams, torque specs, engine info, switches functioning, assemble, disassembly, complete refurbish, repair, installation every single thing is covered

They all still need to be checked with a torque wrench periodically. ... My BA XR6 has developed a clicking/knocking usually while turning while ... There is a torque setting for the nuts, it cast into the sub member near the mounts. ... Maybe thats all the mid-life b series steering click is, the bolts coming loose.

[PDF]BA Torque Specs

members.optusnet.com.au/~matt_l/tridocss_files/ba_torque_specs.pdf

Torque(Nm) Torque(FtLb) ... Cam chain tensioner blade to cylinder head nut ... Front and rear upper mounting bolts .... Front Suspension/Steering .... NOTE: In stages A and B a torque wrench of known and accurate calibration must be used.

Teleflex Mechanical Steering Tech Reference & FAQ

www.jamestowndistributors.com > Home > How Tos

I'm replacing a Teleflex rack & pinion cable in a 1985 boat. ... If you have installed a non-tilt "Back Mount Rack Helm," order Friction Kit part number ... Morse Command 200 Rack: use Teleflex Back Mount Rack for power-assisted or NFB Rack for ...torque feedback from the engine (which can make the steering wheel turn on ...

https://www.google.com/search?q=Where+is+obd2+port+on2002+mazda&biw=1362&bih=650&tbm=isch&tbo=u&source=univ&sa=X&ved=0ahUKEwjb68P25JrQAhWC14MKHUfwDxgQsAQIMg#tbm=isch&q=What+are+the+torque+specs.+for+2001+Protege+valve+cover

Hope this helps

40" pounds not 40' lbs
i would do them at 25" lbs. followed by the 40 in. lbs also do every other bolt studer step so it will seat the gasket evenly.

• Tighten retaining bolts in sequence to 80 Nm (59 ft. lbs.).
• Then back off bolts 360°.

CAUTION: Always use new cylinder head bolts when installing cylinder head or damage to engine may occur.

1. Tighten the cylinder head retaining bolts in two final tightening steps in sequence shown in the following illustration:

• 50 Nm (37 ft. lbs.)
• 92 Nm (68 ft. lbs.)

torque it to 65% of the maximum torque rating for that diameter bolt

you need to remove vavle cover and you we se 8 to 10 bolts.but you need to find out the number order to remove bolt so you do not warp the heads also need to unbolt the intake.and your going to need a torque wrench to put it back on.

Well the first thing U need to do is clamp off your break line,{u only have to do this if it has abs}which that year.then you nee to break open the break bleeder vavle.Whants you have don this then you are raedy to unbolt the break housing and remove the breaks and replace.Put back togather and close the bleeder vavle and take the clamp off the break line.Now you are ready to bleed the breaks.The same way for all four.{if your car has disk breaks in the back}