How do i remove dash panel suzuki 2003 - 2003 Suzuki Aerio

in what country?
you left off the dash, XL7 is not a XL-7 but 2003 is best clue.
usa
$4 see the real book, not fake, official

https://suzukipitstopplus.com/Products/10057-2003-grand-vitaragrand-vitara-xl-7-service-manual.aspx

pull the cluster from dash and install lamps check the fuse 1st

please use english here, it's and english forum!
How to change a time korea 2003 suzuki aerio

my guess is the dash time clock is wrong or is it the radio?
you lost the operators guide in the glove box,
this information is in that guide, in all cars made.

Component location diagrams for most 2003 Suzuki Aerio cars and light trucks sold in the U.S. from 1990+.
Ignition System Components Location Diagram for 2003 Suzuki Aerio 2.0 L4 GAS
Components on diagram:

TP Sensor

Ignition Coil

ECM

MAF Sensor

CMP Sensor

Electronic Shift Control System Components Location Diagram for 2003 Suzuki Aerio 2.0 L4 GAS
Components on diagram:

Data Link Connector

Transmission Range Sensor

Throttle Position Sensor

Pressure Control Solenoid Valve

Battery

Instrument Panel For Connector Layout Diagram Diagram for 2003 Suzuki Aerio SX 2.0 L4 GAS
Components on diagram:

Clutch Switch

Thermistor

Brake Light Switch

Blower Motor Relay

Heater Fan Motor

Instrument Panel Harness Diagram for 2003 Suzuki Aerio SX 2.0 L4 GAS
Components on diagram:

Wiper Switch

Washer Switch

Data Link Connector

Turn Signal Relay

Radio

Headlight System Location Diagram for 2003 Suzuki Aerio SX 2.0 L4 GAS
Components on diagram:

Headlight Relay

Headlight

Clearance Light

Headlight Diode

Clearance Light Relay

Fuel System Components Diagram for 2003 Suzuki Aerio SX 2.0 L4 GAS
Components on diagram:

Fuel Pump Relay

Fuel Tank Pressure Sensor

EVAP Canister

Fuel Tank Pressure Control Valve

Fuel Filler Cap

Floor For Single Unit Parts Diagram for 2003 Suzuki Aerio 2.0 L4 GAS
Components on diagram:

Wheel Speed Sensor

ABS Control Module

G Sensor

Air Bag Control Module

EVAP Canister Vent Valve

Instrument Panel For Ground Point Diagram for 2003 Suzuki Aerio SX 2.0 L4 GAS
Components on diagram:

Instrument Panel Ground Points

Engine Compartment For Single Unit Parts Diagram for 2003 Suzuki Aerio 2.0 L4 GAS
Components on diagram:

Throttle Position Sensor

Horn Relay

Radiator Fan Control Relay

Cruise Control Module

Condenser Fan Relay

Engine Compartment Components Diagram for 2003 Suzuki Aerio SX 2.0 L4 GAS
Components on diagram:

MAP Sensor

Knock Sensor

Noise Suppressor

Heated Oxygen Sensor

Radiator cooling fan 2, control system malfunction. Check fuses under hood & in fuse panel under dash. If all are good check for power & ground to radiator fan motors. Verify motors work by powering up with jumper wires. If they work may have bad relay. If they dont work will need to replace motor.

its called the TCM. (on most cars now, its inside the PCM)
not this car, in USA. as above gets wrong.


The Engine Control Module (ECM) is located in the passenger side of the instrument panel behind the glove box.

the TCM is center of dash or console. not where ECM is..located. sorry, !
on 2.3L and 2.0L USA cars.
its here.
right dash is ECM
center is TCM. fact. this page is from the real service man.
seen here,

The knob cover easily pulls off. To remove the entire control, pry trim panel off, then remove screws that hold on controls and remove it.

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls

start with the screws on the bottom of the stereo..they are located on the area above the shift knob where you could place misc items compartment.

How do i remove the tail gate door panel on a suzuki gran vitara as i have to replace a broken door handle?