Car wont start has draw from the btn fuse need to know whats on the fuse to further trouble shoot
I have a kia carnival with the same problem.
When I take out the btn fuse, the battery stays charged, but the transmission won't shift out of third gear.
It seems unrelated to the tail lights or number plate lights.
Brake and taillights. Either your brake lights are on all the time, or if your have a trailer hitch the wires for that are messed up?
Quote: "Since you have isolated which system is guilty you can further isolate the components. Try disconnecting the wires to the tail light assemblies (one at a time) with the fuse in place and see if the draw disappears. Do this with the brake light switch, headlight switch, and even the relays and you may be able to narrow it down to a single component or a certain strectch of wiring..."
https://answers.yahoo.com/question/index?qid=20070213164332AAfd7N5
SOURCE: Transmission fluid capacity for 2000 Kia Sephia?
The four speed automatic shows a total fill (that is all the fluid it can hold) is 5.7 Quarts. So if you just dropped the pan and relplaced the filter, you shouldnt need more than 4 quarts and likely you would have a little extra with that.
SOURCE: Cant find thermostat on 2000 kia sephia.
Try tracing out the upper radiator hose from the radiator to the engine. The end that it is connected to on the engine is usually the thermostat housing.
SOURCE: 2000 kia sephia clutch
this is a big job for someone who is not mechanically inclined but....here it goes go buy a new clutch new tranny fluid and a haynes manual at the auto parts store your going to have to drain and drop your tranny ... BUY THE CLUTCH WITH THE TOOL theres an alignment tool needed to align the plates n bearings start by pulling off both tires, brakes and both cv axels be sure to remove the intermediate shaft from the tranny on the passenger side (should come out with the axel passenger side only) so do yourself a favor and buy an impact gun with at least 500 ft lbs torque youll need it also have handy your 14mm 17mm and 19mm impact sockets and remember this job usually runs around 1,200 bucks at firestone also DO NOT remove the bolt in the middle of the front springs under the hood just the four around it and the will pop out no prob and wont need to be clamped remove the starter behind your engine its under the oil filter also if your new to this sorta thing its gonna take you about 3 days to do it buy the impact gun if ur in a hurry look at a pawn shop have your flywheel machined its going to be accessible and it needs it hope this helps dont forget the book which you should already have bought anyway its good for your torque specs which you will also need a torque wrench for the clutch also dont crack open ur tranny this isnt a honda
SOURCE: 2000 kia sephia fuse box dirmgram
hi..you can get the diagram from the following
link.
http://images.google.co.in/imgres?imgurl=http://www.bigcee.com/faq/KLR650-color-wiring-diagram.jpg&imgrefurl=http://www.wiring-diagram.com/&usg=__Feaf0TWiqoQBMFEeM3HxCyDYqI4=&h=2400&w=3000&sz=559&hl=en&start=6&um=1&tbnid=n2YR-OYbgOHpZM:&tbnh=120&tbnw=150&prev=/images%3Fq%3D2000%2Bkia%2Bsephia%2Bfuse%2Bbox%2Bdiagram%26ndsp%3D20%26um%3D1%26hl%3Den%26sa%3DN
check it out..
thank u..
rate me..
750 views
Usually answered in minutes!
×