Auto transmission sticks in gear and kills engine when stopping
SOURCE: Transmission shifting proublem M5R1 1997 FORD RANGER
You might have to try to adjust the freedom of clutch pedal,
The noise during shifting can be adressed to exessive wear clutch parts or again it might be a sign that indicates the not complete enabling the calutch
To find out what is causing the noise, set the parking brake, place the vehicle in neutral and start the engine.
If you hear growling or grinding noises when the clutch is engaged, the cause is the transmission input shaft bearing.
A squealing sound that occurs when the clutch pedal is depressed and held is usually caused by a bad pilot bearing or bushing.
A chirping noise that intensifies when the pedal is slowly depressed would indicate a bad release bearing.
If you hear chirping while idling in neutral and the noise goes away when the pedal is slowly depressed, the fork/pivot ball contact point is making the noise
Hope that helps.
The clutch adjustment procedure you can find at
http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c1528018f021
More about clutches
http://www.aa1car.com/library/2002/ic100237.htm
Good Luck
SOURCE: Auto Transmission
Try shifting the trans manually through the gears and see what happens,doesnt cost anything so,possibility valves are sticking in the valvebody after sitting so long,and manually shifting the car will force some of them to stroke in their bores unless REALLY stuck.Could also be shift solenoids.Scan for diagnostic trouble codes.A bad solenoid will have set a trouble code.Just FYI,1991 was the first year Ford went to all electronic trans,i had a 91 Sable.
SOURCE: 2002 Ford Ranger Clutch Problems
It's not the clutch, it is the clutch slave cylinder. Check the fluid level in the clutch master cylinder and you will see that it will be empty. The problem is the trans has to be removed to replace it.
SOURCE: Auto trans fluid top up on AU falcon
get new plug 1st then use plenty CRC ,hammer and blunt chiesel or blunt centre punch to crack plug(turn around or undo)
SOURCE: i replaced my auto transmission with overdrive in
switch to a manuel transmission...
The ford A4LD transmissions are one of the worst transmissions ever manufactured...
When you did the swap , did you flush the lines and use a rebilt torque converter?
71 views
Usually answered in minutes!
×